Forum Replies Created
-
Posts
-
Re: bosch f21 fault
To clear an F21 error , you will need to enter the test programme.
Set selector switch to off
Turn selector switch to 6 o’clock position
Hold spin speed button then turn selector switch one position clockwise ( 7 o’clock )
The machine should now be in test programme
Turn selector switch back to off then on again and it should be back to normalRe: Belling dishwasher lower door seal IDW602/2
I think you have to buy the complete door inner, crazy 😥
Re: Indesit washing machine explodes
Looks like they are milking this for all it is worth, however Indesit are so poor now that I decided last week to no longer take on any new Indesit customers. Glad to see the back of this cr*p.
Graham
Re: famous customers?
Had to suffer Dave Lee Travis a couple of years ago, very demanding.
I also go to Graham Poll, every time I go there I am tempted to give him 3 receipts 😆Re: Bosch WAA28160GB/01 Replacement Drum bearings?
Could be an error on their drawing I reckon.
You could buy the seal and source some bearings elsewhere.Graham.
Re: Zanussi WJD1257W Dryer not working
Broken wire on lower thermistor terminal maybe, it is very common.
Graham
Re: Hotpoint WMA34 Not Spinning
The brushes are not the problem. It could be the motor, power module or broken wire.
Graham.Re: Bosch WFX3268GB/23 drum same as WFLI2440GB/14???
They are different 😥
You can double check on the bshappliancecare web site.Graham
Re: Best cheap brand to sell?
Not heard of this make before. Will start to recommend them as a budget machine.
Graham
Re: Siemens Dishwasher SE60T390 GB 01 Help
Went back today and drained off all the rinse aid from the dispenser and replaced it with Finish rinse aid. She was using Sainsbury`s own brand.
I also gave her a box of Finish powder.
Told her to give that a try but if no better to call Siemens, I have done all I can really 😕
She did not seem that unhappy as she insisted on giving me £50 for my time. 🙂
Still I always learn something on jobs like this.Thanks for all your help everyone
Graham
Re: Siemens Dishwasher SE60T390 GB 01 Help
Sat through the auto wash cycle today nearly 2 hrs!
00.00 mins- Starts and fills to correct level.
20.00 mins -heater on
35.00 mins- heater off. Water Temp 50 Degrees
75 mins- Starts cold rinse
90 mins- Hot rinse at 68 Degrees
110 mins heater off and wash ends.Went back 2 hrs later to check if it had dried ok and I must admit the interior of the machine was quite wet.
But the customers claim that it does not get hot enough on this cycle is incorrect I feel.
She is convinced the problem is the new board I have fitted but on todays tests I cannot see this is the case.
Tried it on the quick wash and it seemed to dry better with only the left hand side ot the inner cabinet being wet.
Rinse aid set on 4, salt set on 5, drying set on normal.Any more suggestion please.
Graham
