Forum Replies Created
-
Posts
-
Re: Hotpoint Aquarius VTD00 – Stopped working..
maybe the capacitor, although this is usually a fault mainly on the CTD00 condenser dryer, yours is a vented type. With the lid off, start it up and push the drum round by hand, if it starts-its the capacitor
Re: hotpoint wd420
had one yesterday, it was the module. But check it fills in pre wash tray first, then it should fill in main wash tray, if it is only prewash then maybe solenoid valve for main wash that is the fault. If both ok then module faulty
Re: electrolux EWX12550W
yes i have had loads of them, it is a known fault on electrolux/zanussi/aeg machines. Replace the interlock-the new ones are slightly different to the original. Apparently its costing electrolux loads by trying to save a few pence using inferior parts and having to replace the interlocks under warranty.
Re: Belling or De Dietrich freestanding advice
belling are part of glen dimplex, they also have new world and stoves brands, there is not much difference between them all. Belling cookers are quite good quality but it is just a name. they used to be one of the best freestanding makes when they were built in the enfield factory.
Re: Hotpoint Washer/Dryer WDD960P F13 Fault
i have made 6 holes in each square on the mesh filter with a screwdriver, this increases air flow but for some reason the drier heater can develop earth faults within a few months as excess moisture in heater circuit, there have been numerous design changes on this heater box over the years, some with, some without the mesh filter, all attempts never that good
Re: Indesit DE73UK – Error A13
i have had this fault when i worked for indesit years ago, replaced pcb and dispenser, both made no difference and machine got exchanged. Give up on it-you have had 10 years out of it
Re: hoover vhc391
thanks helo_75 i just needed sombody else thats had same fault to reply. It always seems the case that what ever question i post i have very few responses.
Re: bhwd129 no motor action but only on wash
yes it must be the module, if it was the motor it would give fault lights on the display
Re: Amica 51EE1.30PFG 52743
easy-screws at back of hob part must be removed and it slides forward and off, i would change the hotplates as the regulators are switches
Re: hotpoint boots
i used to work for hotpoint and never fitted the 1605335, always fitted 1605550 fits all wf and wt machines but not wma
Re: whirlpool adg 7460 dishwasher
i had the same fault and got no replies, but would still like to know what was causing it
