Forum Replies Created
-
Posts
-
Re: Stoves oven cooling fan not working
there is a pcb on these ovens, normally this that needs replacing
Re: When is Service not a Service ?
thats one of the reasons i left ind/hotpoint. most employed engineers dont have a clue, franchise engineers much better as if they get a recall within 30 days, they dont get paid, employed engineers order anything and everything and get away with it.
Re: Whats the strangest fault you have come across?
ive found a dead rat across the live and neutral terminals on a hotpoint electric cooker, it was causing the rcd to trip! removed it and cooker was ok, wouldnt fancy eating anything cooked on that cooker though!
Re: Indesit Dishwasher
i would say motor, it may start off ok, give it 5-10 mins and it will run slow, very common fault
Re: BFI620 Hotpoint Dishwasher Lower seal
there is a extra lower door seal that clips on, the part number is C00056475, it is supplied with clips, you have to remove the outer door panel to fit it
Re: Indesit DE73 (309017248) Dishwasher
i have had this fault a few years ago and found that the thermostats that are in a plastic holder (2 stats i think) located near sump did not make proper contact with the stainless steel so unable to detect temperature, i found easiest way was to superglue stats to stainless steel, it worked with no problems, no doubt somebody will call it a botch but it worked. first of all i changed the thermostats but they did not make contact with the stainless steel so did not cure the fault.
Re: hotpoint wf645
come across a lot of hotpoint machines leaking from the dispenser area. I have changed complete dispensers,drawers and hoses etc but could not stop these leaks, i have even turned these jobs away as it is recall after recall and make no money from these jobs-i refer them back to hotpoint and let them try-usually without success
Re: dirty sand like remains on dishes/cups
sandy residue left is due to the fact the sparay arms are not spinning properly, they must be blocked or obstructed in some way-check the holes in the spray arms are clear
Re: hotpoint aqualtis door seal/boot
done loads of them, no different to any other ind/hot machine, just bigger and locating point at 11 o`clock-easy
Re: BEKO Tacho Magnet Needed!!!!
i phoned qualtex that contacted beko and they said it is available as a spare part
Re: Drain pump for obselete Bauknecht WA9430 washing machine
there is an alternative part 481231018314 available from qualtex for £46.74, the part i have is probably the same pump motor but a different housing
Re: Question for the ( older ) Zanussi guys..
i see your from newbury-the home of zanussi, did my training there in 86-87, did you buy your fm31 direct from zanussi?
