Forum Replies Created
-
Posts
-
Re: Indesit washing machine explodes
Just seen photo’s of the latest Indesit we have been out too and it’s scary. The appliance bounced up and snapped the worktop in half, pushing the sink out. It then carried on out of it’s space before exploding in the middle of the kitchen after ripping the water pipes out of the wall causing a major flood. The worst of it is, the top counter weight bolt has been fired through the lid when the appliance was out, has gone through the customers plastic cladded ceiling and embedded itself into the floorboards of the room above.
This is the worst one I have seen and if the bolt had hit someone, would have caused serious injury or even deathRe: Comet/BestBuy link?
Thats news to me.I don’t think it’s true but I’m just an engineer and as usual, the last to know
Re: H2O & F01
Confirm Martins diagnosis, Motor triac fault, has poss taken module out, sometimes you fit a new lock and it works for a couple of washes but goes again.
The new ones are even worse, the modules have to be re written due to a faulty eprom file that sends the motor into a full reverse spin a split second after doing a clockwise spin. Can result in a big bang as the motor segments fly off and a costly repair as usually blows the module as well. Customer also complains of seeing sparks coming from underneath the machines. :rolls:Re: fisher paykel dishwasher
Not been out to one but the other engineers have said they are not nice. They have a technical helpline, just pretend to be an engineer working on behalf of an agent if they ask
0845 062 2300
😉Re: whirlpool awod 4605 859233316106 drum unit
if the 12nc number ends in15103 0r 15104 onwards then its a welded tub, 15100 and 15102 are split tubs thats why it’s critical to get the 12nc correct when ordering parts
Re: indesit WIA 101 uk
anti crease is number 1 and then the 3 below are classed as 2.3 & 4. Looks like f10 error
LCD
Display
Code*
Console LEDs Possible Causes & Actions
Refer also to Additional Fault Code Details
for more information
Key 1 Key 2 Key 3 Key 4
F01 OFF OFF OFF Flash Motor triac short circuit: check motor & module connections
F02 OFF OFF Flash OFF Motor jammed / tacho detached: check motor
& module connections
F03 OFF OFF Flash Flash NTC short/open circuit: check thermistor & module
connections
F04 OFF Flash OFF OFF Pressure switch jammed on empty: check switch & module
F05 OFF Flash OFF Flash Pressure switch jammed on full or pump blocked: check
pump & switch
F06 OFF Flash Flash OFF N/A
F07 OFF Flash Flash Flash Heater relay stuck: check heater and module connections
F08 Flash OFF OFF OFF Heater relay stuck: check pressure switch, heater & module
connections
F09 Flash OFF OFF Flash Setup error: check eeprom
F10 Flash OFF Flash OFF Pressure switch not sensing: check switch & module
connections
F11 Flash OFF Flash Flash Pump cannot be activated: check pump, connections &
wiring
F13 Flash Flash OFF Flash N/A
F14 Flash Flash Flash OFF N/A
F15 Flash Flash Flash Flash N/A
F16 OFF OFF OFF OFF N/A
F17 OFF OFF OFF Flash Door lock error: check door, door lock & module connections
F18 OFF OFF Flash OFF Communication error (3 phase motor): replace power
boardRe: lg grf218 error code
Communication problem between main and display pcb
on left of display
f5 = freezer sensor fail
r5 = refrig sensor 1 fail
o5 = frost removal sensor fail
dH = frost removal is poor
ff = fan failure freezer
cf = fan failure in motor chamber
co = comm error pcbson right of pcb
Lo – room temp less than 10 degrees
Hi – room 50 degrees +
ER- room temp sensor failRe: Bosch T/D WTV74306GB/02 Not drying
ERROR 9 is the same on dryers and W/M. Could be a pcb fault. Engineers manual states :-
E:09
Drying tunnel outlet NTC error Drying tunnel outlet NTC broken or shortcircuit FATAL ERROR
– washing or drying programme aborted
– door is locked possibly; display frozen
– operator control actions are blocked
– check drying tunnel outlet NTC
– and drying unit wire harnessRe: Whirlpool Dish washer 854500015810 hose
spotted that thread as well K, he said he used the hose that goes from the filter to the pump off a Servis W/M
Re: Delonghi EOF260 cooker
1A,2A &4A ARE ALL LOOPED TOGETHER WITH THE NEUTRAL FROM THE MAINS BLOCK, 5A GOES TO THE THERMAL CUT OUT OF THE OVEN
TEH OTHER SIDE OF THE SWITCH IS
5 = OVEN LAMP/STAT
4 = FAN
3 = GRILL ELEMENT
2 = CIRC ELEMENT
1 = WIRE LEFT OVERthe diag I have is pretty poor so hope this helps
Re: Whirlpool AWO/D5526
depends on the product number, some versions are split tub, tend to be earlier versions but most are welded as from a couple of years ago. Need the number starting with 8
