[WhiteVanMan1]

Re: Siemens se24t250gb/32 prog times to pot

Could be a blockage in the pressure chamber/sump hose. that causes all sorts of display problems. It is unlikely to be the module. Steve.

[WhiteVanMan1]

Re: Siemens WM16S796GB/03

That’s great Dave, thanks for your reply, I will let you know how it goes. Cheers. Steve.

[WhiteVanMan1]

Re: Zanussi ZWD12270W

Cheers Jem. It would seem that your assessment was correct. I checked out the dryer heaters, one read 50 megs, the other 10 megs. After disconnecting the heaters, the machine fired up ok. Reconnecting the heaters did not reinstate the fault, and it has been working ok for over a month now. Clearly there is some point where the dryer causes a fault, but I have left it as it is for now. New tenant in a rented house and all that. Thanks once again. Steve.

[WhiteVanMan1]

Re: Neff dishwasher S4943N1/08 info

I don’t know of any test procedures or error reading on these appliances, but the usual cause of this is a blockage in the pressure chamber or sump hose. Steve.

[WhiteVanMan1]

Re: Hotpoint 9605 Top Loading w/m Spin Problem

All of the above, but another possibility is something stuck in the drum or around the main seal on top of the power unit.

[WhiteVanMan1]

Re: Hotpoint WML 560P

Thanks Iadom. Yes, I checked motor connections, all ok. Cheers. Steve.

[WhiteVanMan1]

Re: Miele W980 Washing Machine

Thanks Seamy, have done all that. Conclusion is that the PCB must be faulty on the power supply side. Cheers. Steve.

[WhiteVanMan1]

Re: Neff Dishwasher Model S5555XOGB/79

Yes, I sort of worked that out, but that is not the fault I have had in the past with the impellor jug. However, I thank you, and I think it is one to watch in future. Steve.

[WhiteVanMan1]

Re: Neff dishwasher

I’m not sure which one this is, but after a recent problem I had, it it has the impellor jug fitted, that is what I would go for. It could be the aquastop valve if it has aquastop. I kow it’s a bit vague, but hope it may be of use. Steve.

[WhiteVanMan1]

Re: Neff Dishwasher Model S5555XOGB/79

Hi Paul. Thank you for advice re Neff dishwasher. You were quite correct, it was the impellor jug. It has all dropped into place now I think. I was thinking that there was a timed fill facility through the module, but clearly it seems that the impellor jug measures the water allowed into the appliance. I assumed the impellor jug was to measure the rate of flow, and therefore also the water pressure, as was the case on most of the old dishwashers through the pressure diaphram valves that they used to fit. Just goes to show doesn’t it. Thanks again. Steve.

[WhiteVanMan1]

Re: Neff Dishwasher Model S5555XOGB/79

Thanks for that Paul. The only impellor jug fault I have had in the past stopped it from filling. I have no doubt that you are correct though. I will keep you informed. Thank you. Steve.

[WhiteVanMan1]

Re: Hotpoint FF 200 EG Fridge Freezer

That’s because I’m a dipstick TM, and posted the wrong make. I’ve corrected it now. Cheers. Steve.

[WhiteVanMan1]

Re: Hotpoint FF 200 EG Fridge Freezer

That’s because I’m a dipstick TM, and posted the wrong make. I’ve corrected it now. Cheers.

[WhiteVanMan1]

Re: Hotpoint FF 72 N Frost Free Fridge Freezer

Cheers loopey. Just to let you know that new thermistor did the job. Thanks again. Steve.

[WhiteVanMan1]

Re: Hotpoint FF 72 N Frost Free Fridge Freezer

Thank you for that loopey, it was my first thought, but the display temperature threw me a bit. I’ve ordered thermistor, and will, let you know. Cheers. Steve.

[Author]

Posts