[wilf]

Re: Rogue customer

how can you work without taking cheques?

wilf

[wilf]

Re: neff washer E14

thanks. didnt think this would stop just the washer.

wilf

[wilf]

Re: Rumour/Proposed Vat drop

have a look at the robert peston blog on the bbc. he talks of a possible rise to 22{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} to pay for borrowing. however things turn out I cant see it doing much for us in the long term.

wilf

[wilf]

Re: First Indesit smart card job completed

you poor sod!!!!!!!!!!!!

wilf

[wilf]

Re: Indesit WIA121

had the same last week unblocked the outlet drained ok then tried it again on wash, continuous fill and would not reset.
you need a new board see EMW
not your fault if the customer buys rubbish!
I always worry about these things and point out to customers there poor reputation

wilf

[wilf]

Re: Was it something I said.

squash ball…..hammering………bad day….could equal hernia

might be better of with a nice cup of coco

wilf 😆

[wilf]

Re: Hoover HNF 6127-80 NO GO

is the board configured? apparantly some are and some are not. it caught me out a while back, dont know how you tell one part from the other as an old mate from candy gave me the info and had a second hand board that got me out of the nasty stuff!
check with hoover

wilf

[wilf]

Re: Work Lighting

8 watt flourescent leadlight from aldi/lidls three quid when there in stock. I keep one in the office as a spare. thin enough to hang down the inside of a washer fits inside oven etc wouldnt be without one.

wilf

[wilf]

Re: Zan and Bendix wiring

it it not dst1249644004 ?

wilf

[wilf]

Re: Hotpoint wm31 cuts out

on off switch burnt?

wilf

[wilf]

Re: Hotpoint F08 fault

I,ve had a few where its the heater gone and the board ok

wilf

[wilf]

Re: Hotpoint WD64

no short cuts I’m afraid clean the duct, its the only vent. seems that every time I’ve had this I’ve always ended up doing this.

wilf

[wilf]

Re: Zanussi ZJ1218 no display

watch out for damaged minature start switch on the display board caught me out a few weeks back machine was doing all sorts of strange things. when I took the front off to check the harness I found the top of the switch inside the front panel got the local electronics bod to solder on a new one and all ok

wilf

[wilf]

Re: indesit IS70C

the best way I’ve found is to remove both sides and back and capacitor support the front door etc .fit the belt to the motor and hang it to the side of the machine. push the drum into the belt and adjust it to its running position. then roll the drum over the motor into the dryer with the belt fitting correctly onto the jockey pulley. fit the drum onto the front guides. fit the back panel and lever up the rear of the drum and fit the rear bearing to hold it together.
other people might use other ways but this works for me!

wilf

[wilf]

Re: hotpoint 9538 thermostat wiring

grey grey to thermostat no 2 thats the one pointing out towards you
brown black to thermostat no 1 thats the one near to no 2
red to thermostat no 4 thats the one the other side from the other two

wilf

[Author]

Posts