Forum Replies Created
-
Posts
-
Re: diplomat dishwasher
The dishwasher is Diplomat 12034.
The little neon lite on the right side is on when the power switch (the first on the left) is pressed in. But the start Pushbutton) does nothing.Re: Zanussi DX6453 – Flashing End Light
Hi Martin,
Just double-checked, definately 6 flashes!!! Pause, then 6 flashes etc etc…
I suspect I’ll be on the ‘phone tommorrow!
Andy.
Re: Hotpoint DWF 70 Power down
Whole machine instantly powers down. Pressing the power button powers it back up, and then off it goes from where it left off, sometimes completing the cycle right to the end.
Re: indesit wd12uk fault code 3 flashes
FOUND THE PROBLEM WITH THE NEW BOARD TOOK IT OUT TO INSPECT AS CHECKED THE SENSOR AND WAS OK,WHILE LOOKING AT THE BOARD NOTICED THE NEW BOARD HAD AN IC HOLDER BUT NO IC IN IT DESOLDERED THE ONE FROM THE OLD BOARD PUT IT IN THE NEW BOARD AND IT WORKED.QUESTION IS DO THESE CONTROL BOARDS ALWAYS COME WITHOUT THIS IC,USED TO SERVICE WHITE GOODS 10 YEARS AGO SO MACHINES HAVE OBVIOUSLY CHANGED ALOT SINCE THEN,THIS WAS DONE AS A FAVOUR FOR A FRIEND BUT I PRESUMED WHEN I ORDERED A NEW CONTROL MODULE IT WOULD HAVE BEEN COMPLETE AND JUST A STRAIGHT SWAP
Re: Blomberg 1501 AAA Fault’s
I have basically the same issue with the conditioner. How do I go about cleaning the dispenser? I have taken the drawer out but can’t get access to the jets in the roof of the drawer slot.
please help
Re: NEB Vicenza Mirr oven
Hello all, thankyou for all your posts. 😆 The cooker is typically out of its warranty, isn’t it always the case!!!! 🙁 we don’t even know what the element looks like or where to find it so we are stuck like the perverbial river boat and paddle!!!! Gonna try to get a hold of the directories for repairs. I cant stand the smell of deep fried food so me and my other half are not seeing eye to eye at the moment seen as he threw the manual away in one of his infrequent spring cleaning frenzies, this is why women do it and men shouldn’t:lol: !!! Ar well wish him luck finding the problem, he is gonna need it. Thanks for all your help
Re: hotpoint dwf 50 with flashing eco light.
Thanks Dave and JohnnyJ,
I took base off and it was full of water. Machine works okay now but i am abit worried where the water has come from.
Thanks again.
Brian
Re: Corgi cowboys?
“Another fine mess you’ve got me into” was a phrase the late “Oliver and Hardy used to come out with…..
And no matter what the mess I’m afraid I have to go with the law of the land, even if I can’t see the sense of it.The way forward is not in condoning or sanctioning “breaking” the rules and regulations even when common sense dictates otherwise!
Sorry Martin, if the guy does not want to requalify he should cease doing it.
KevinRe: My Zanussi FJS1425 says E40 door open when not. Any idea
If it is, well it doesn’t seem to do that as the door closes either way
Re: how to find an new PCB for Indesit
Thank’s DAVE!…
I have another problem whith an new Miele wt945 novotronic (that’s UK made)…error flashing…( I can say i’ts brand new)
I try to explain for you what’s happend…
It was an whater leak out from an dryer-fun tube to main noise-filter—which blouw-up…,
I replace the tube and the filter and he works fine few times… and now he stops in diferent stages (like after fills whith whater; after heating session; between rinses) and the lad’s from ON;END still lighting and the RINSE lad is flashing…Can you help me…
Re: Error C2 on AEG OKO_Favorit dishwasher
Dave,
Thanks for the reply. I have just checked the drain point at the sink and it is fine. I also lowered the drain hose and got some clean water out of it (cleaner than the water in the machine). The drain from the sink is also OK. Could it be blocked between the sump (the easily accessible one below the filter) and the outlet from the dishwasher?
Do you know if it would give another error if the drain pump has gone?
Thanks
rol
