[Bernie]

Re: Whirlpool AWM6163 Bearing seal-v ring

Connections have a picture there part no. 5031681972022

Thanks for getting back Dave

Bernie

[Bernie]

Re: Indesit Moon SIXL145

You can try here

Indesit Error Messages and Error Codes:-

http://www.indesitservice.co.uk/hs/page … RROR_CODES

[Bernie]

Re: ind wixe 127 uk

I found this:-

Indesit wie 167 washing machine flashes the word ‘test’ and then ‘F-03’

Looks like you may have open/short circuit on the wash thermistor

Indesit Error Messages and Error Codes:-

http://www.indesitservice.co.uk/hs/page … RROR_CODES

Don’t know if it might help

[Bernie]

Re: Indesit WIXL123UK/Y Die’s then starts up again

Thank for the explanation baron

[Bernie]

Re: Indesit WIXL123UK/Y Die’s then starts up again

Thanks for that Jonnieboy I’ll give that a look

Bernie

[Bernie]

Re: Indesit WIXL123UK/Y Die’s then starts up again

Thanks for the reply Baron.

I get the door lock but not the bit that follows…….make a jump between J4.1 and J4.2 on PCB with J4 connector OUT and let wash program run till end…
what will this tell me?

what do I make a jumper from, which one is the J4 connector?

Also “missing carbon brushes?” do you mean a brushless motor?

Bernie

[Bernie]

Re: Indesit WIXL123UK/Y Die’s then starts up again

Do you mean the connection between the display module and the main module?

[Bernie]

Re: Indesit WIXL123UK/Y Die’s then starts up again

Thanks for the reply Martin.

If it was a mains power failure won’t the wash led go out also?

When it was spinning and it goes of the spin led stays on too

Berne

[Bernie]

Re: Bosch WAE24363GB no fast spin

Thanks for the tip Nelson

[Bernie]

Re: Door seal retaining spring pliers

I use a large cable tie around the band, so you have something to get hold of you can either leave it there for next time or cut it off.

I would add to be extremely careful as I was changing the door seal on a late Whirlpool using the above method when the spring came off one end of the clamp and my hand shot up and hit the crossbar cutting the thumb down to and nicking the tendon, I had an op to repair it. Now I am off work for 10 to 12 weeks.

Bernie

[Bernie]

Re: hotpoint WF560 No Spin

Thanks for that but the motor is a brushless one.
I have now found out that the customer had changed the belt it was the wrong one to long fitted correct one all ok now

Bernie

[Bernie]

Re: hotpoint WF560 No Spin

I have just tried a pressure switch still will not spin

Bernie

[Bernie]

Re: Whirlpool AWO/R4205

Anybody know how long it would stay on wash at 40 deg? I waited about an hour

Bernie

[Bernie]

Re: whirpool awo/d

Whirlpools have been leaking from the draw for years. I just silicon up the front row of holes in the dispenser

Bernie

[Bernie]

Re: Indesit Dishwasher IDL500UK

Thanks for that THT

I have ordered one, as you say about a tenner from Connect

Bernie

[Author]

Posts