Forum Replies Created
-
AuthorPosts
-
captaincaveman1
ParticipantRe: removing the balance weights of a washing machine
You might as a well leave it at your old apartment because if you do attempt it you’ll end up having to buy a new machine anyway.
captaincaveman1
ParticipantRe: Beko WMP652W – cutting on and off
That board is for the motor had one yesterday where the main pcb was ramping the motor straight to spin which made this dc board blow but it could just as easily be the motor at fault.
captaincaveman1
ParticipantRe: Beko Freezer TFF673AP W
Yes you wont hear a click as it has no thermostat as it’s electronic and being frost free they tend to run a lot more often then a traditional freezer would so you need not worry.
captaincaveman1
ParticipantRe: Zanussi ZDC 47200W water tank problem
Yes the top picture is the complete assembly
captaincaveman1
ParticipantRe: Zanussi ZDC 47200W water tank problem
The valve has sprung apart as the small “o” seal has worn off the back of it causing the rest of it to spring out when you last removed the tank.
captaincaveman1
ParticipantRe: Zanussi ZNG1120M
Your right Seamy not on the kickplate the proper Zanussi has no kickplate just the filter aperture.
captaincaveman1
ParticipantRe: Zanussi ZNG1120M
These machine’s have never seen a Zanussi factory. Mainly were sold through Comet as “The manager’s special” and as the creator of this thread said it is shameful that this deception is allowed as he bought the machine for his daughter on the basis of the good service of his proper Zanussi machine. I know Electrolux need to try and compete with the like’s of Beko but ruining the Zanussi reputation isn’t the way forward. If you want a proper Zanussi make sure it has the rectangular filter cover on the bottom front right corner.
captaincaveman1
ParticipantRe: PLEASE HELP BEKO WM5100W Problem
Have you tried a different socket firstly??? If so then if you tilted it over to the right when transporting it then any residue water that was in the soap drawer may now of got into the circuit board.
captaincaveman1
ParticipantRe: White Knight 77AW condenser dryer
Check front fan is clear you can do this by tilting it backwards you can see the fan in the front right corner sometime’s this become’s blocked.
captaincaveman1
ParticipantRe: Went to work in my pyjamas…
I must admit I never charge neighbour’s either .I’ve only only been getting called upon since my latest van has marking’s all over it though!!!!
December 28, 2013 at 5:52 am in reply to: Zanussi ZDC37200W Condenser Tumble Dryer – Keeps stopping #406740captaincaveman1
ParticipantRe: Zanussi ZDC37200W Condenser Tumble Dryer – Keeps stoppin
Could be the motor capacitor fault as this “kick start’s” the motor into action.
captaincaveman1
ParticipantRe: Family washing machine
Look for one that has an inverter motor as these are the quietest. It will be listed at the point of sale for it is seen as a sale’s feature.
December 21, 2013 at 11:16 am in reply to: Beko DSFN1534B won’t go through the full wash cycle #406449captaincaveman1
ParticipantRe: Beko DSFN1534B won’t go through the full wash cycle
If there was a problem wit the draining which now you have now sorted then as seamy suggested it will of spilt water into the base and activated the anti flood device. Switch off appliance place a towel to one side and tip the appliance slightly toward the towel and water will spill out this should reset it.
December 21, 2013 at 11:03 am in reply to: Haier washing machines comes with two years guarantee?? #406646captaincaveman1
ParticipantRe: Haier washing machines comes with two years guarantee??
There’s a store near me similer to Home and bargains “BUT ITS NOT THEM !!” selling an “Electra” (Now there’s a name thought had disappeared ) washer for £129 I’m not sure who make’s it but ive also seen it at a customer’s badged as a Zanussi sold through John lewis Proberly for a far larger mark up it has no access panel at the back and looks like it wouldn’t last a week in a sheltered accommodation laundry room anyone know who may make it . Vestel perhaps???
captaincaveman1
ParticipantRe: The Forthcoming Apocalypse
Thank god for Beko’s fan motors and element’s let’s hope they don’t improve!
-
AuthorPosts
