[eastlmark]

Re: No water to bottom spray arm…any advice eplease

dont know that model at all but as it has a valve it probably means it has a half load setting, has the half load been set accidently?

[eastlmark]

Re: Diplomat ADP 8112 Dishwasher

check that dispenser coil before doing anything!

[eastlmark]

Re: No Credit Card, No Repair

Dont blame them though, customer abuse and atitiude is reaching the point where I am thinking of doing the same, for new customers at least. At least then they might be arsed to stay in for us.

[eastlmark]

Re: Ceramic Hob – ET4T- AO/TQH 4000/1

BSH model number, isn’t it?
ET4TI20/01 HOBS
ET4TI40/01 HOBS
ET4TIA0/01 Hobs
ET4TIA1/01 Electric hotplate
ET4TIA2(00) Electric cooktop
ET4TIA2/01 Electric cooktop
ET4TIA2/02 Electric cooktop
ET4TIA2/03 Electric cooktop

[eastlmark]

Re: The Martin conumdrum.

I would like to publicly state that needlessly bumping this thread for ones own pleasure is childish and unnessesary and I will not be involved in any Martin bating……..did notice it hadnt been bumped for over a day though 😆

[eastlmark]

Re: adp8322

Cannot tell from your post if you replaced the pressure (water indicator) switch or not, often the cause of this problem.

[eastlmark]

Re: Smeg Dishwasher DWF612WH

Although its nowhere near the place where you said the sound is coming from, it does sound like the circulation pump is not running and just humming instead. Could be either a siezed pump (expensive to repair) or a failed capacitor which is bolted to the circulation pump motor (cheap to repair but difficult to access and can only really test by replacement). make sure you unplug if you do take a look but would advise a smeg experienced engineer take a look.

[eastlmark]

Re: Can I Just Say?

Yes, was suggested a while back but probably too soon then, have warmed to him since though. No objections, would have liked to meet the guy first mind, think he is trying to come to next meeting?

[eastlmark]

helo_75 wrote:yep, the valve is supposed to flush the fluff off the filter

if the filter aint there, it serves no purpose

and the pcb wont pick up and error out?

[eastlmark]

Re: Hygena APM8513

there is a APM 8513, module number 546021400.

[eastlmark]

Re: Miele G 646

possibly you have had a leak into the tray that covers the bottom, this operates a float which may bring on the pump and lights. Would need to identify where the leak is coming from which is no easy task on one of those.

[eastlmark]

helo_75 wrote:yup, cut out the filter, and snip the wire to the valve, its the only answer

thanks to both of you for the replys, do you really mean to cut the valve wire?

[eastlmark]

Re: Asko WM110

should be a wiring diagram tucked in the top near the timer…… think that one may have a combined motor….uses induction for wash and brushes for spin…forgive if I am wrong, doing it from memory!

[eastlmark]

Re: dyson vac DC07

mike1 wrote:it will be the motor.
mtr240 from qualtex £16.23

mike

Is it easy to change… for someone who last worked on a Hoover Junior 15 years ago? 😆

[eastlmark]

Re: ISE10 No Stock

just as a matter of interest, what was in the containers then?

[Author]

Posts