Forum Replies Created
-
Posts
-
Re: smeg p662 hob
2 modules on that one, 6916520250 £173.64 & 691650279 £165.60 +vat of course. quote her for both and hope she doesnt give the go ahead!
Re: Smeg A2A range cooker
You need to check all the elements as they can briefly be contacted when turning the knob. But the most likely thing will be a melted or tracked commutator (selector switch). Must admit that the range of smeg ranges is so diverese I often dont know if the “bonnet” lifts up or not till I get there. Most since 2003 do but there is no hard and fast rule about if and how. you can often remove the comm for inspection through the hole left after removing the clock if your lucky! Careful though as a lot of comms have superceded part numbers and you often have to change a fair number of tags as well.
Re: creda/hpt sump filter
If that was the old, hard plastic sump hose then yes, it was crap and you had to line up the slots in the ball housing, if not it does not go in fully and may pull off. The new one is more conventional rubber type.
Re: UK Whitegoods September 2006
Thanks to all involved and all who attended for another great meeting.
PS. sorry if I was crap company for anyone on Friday (esp Andy APG at lunchtime) I was totally wasted all day Friday and could barely sit up straight!
Re: UK Whitegoods September 2006
just a taster of the “continental” style outside drinking on Thursday night.
Re: UK Whitegoods September 2006
Penguin45 wrote:
gegsy wrote:
It will be in post Monday without failBetter do it, or Eastlmark will publish the photographs………..
Mind you, Mark being Mark, he’ll probably publish the photographs anyway 😀
:p45:
the great thing about being the photographer is that you keep yourself out of the pics. 😆 Thanks to Rob Dray for being busy elsewhere.
Re: Electrolux Configuration Codes
iadom wrote:
eastlmark wrote:
the much improved pro corner.Is this only available to authorised agents Mark ?
No, but you need an electrolux distripart account.ps sorry for the late reply, just came across this while searching for something else.
Re: diplomat oven
You will need a new control panel but they are not too expensive but you may need an engineer to fit it. click the link below.
Re: Unknown error code Diplomat 8224
Its a regular fault, but the no heat and half load is not a function on that model so it is best to ignore it as a replacement pcb is a lot of cash.
If you can hear the pump running and the arm is not turning it is probably only due to the the arms being blocked, remove and clean them by shaking the hard bits out through the centre hole. If you cannot hear the pump running then call an engineer.Re: annoying leak on zanussi 1200
white van man helping transit van man, i like it 😆
would need your full model number to assist but some older jetsytems have a rear mounted circulation pump that is prone to leaking.
Re: Zanussi iz16 – Error E40 (E42)
It could be a faulty door interlock or, more likely the power board blown, Needs configuring when a new board is fitted, so would advise expert help on that one.
