Forum Replies Created
-
Posts
-
Re: Hotpoint Forno SHS 33X not heating
are you sure its the thermal limiter you have got ?
there is a thermostat for the cooling fan
you should have C00089573
not C00081599
Dave
Re: Hotpoint 9605 top loader.
as the clutch shoes wear they get smaller and lose weight so don’t work as well
as Lawrence says rough it up a bit but change it if it works
while your there check the pump for leaks as these used to go constantly after the motor change on model 1504 . if these go they leak on the motor and destroy it
Dave
Re: Miele S5000 motor noise/smell
if the motor has gone its a complete motor only, no parts available and a very silly price
Dave
Re: Zanussi ZDT12011FA dishwasher pump reset
have you checked the triac on the pcb for short circuit
pump is connected to b1 and b2 on the board
Dave
Re: Looking for a powerful upright for pet hair – advice?
Sebo every time Dyson is less reliable
Dave
Re: What cap is this
fi tis the cap that normally goes on those boards 680uF 10 Volt
will be on it
Dave
Re: AEG oven temperature always too high
you cannot adjust the temp only change the thermostats
but beware
the top oven is a convection oven that is heated by 2 element. one is part of the grill element and the other one is below the floor. if you place your thermometer on the floor it will be heated by the lower element. it is best to pre heat before adding the thermometer and then it must be on a shelf
the main oven has 2 modes 1 convection as above so the same rules apply but also 2 fan mode which will be hotter where the air exits the fan unit at the rear. so its important to put the thermometer central
Dave
Re: Panasonic Microwave
never heard of this but it is a user instruction not an engineering fault so it must be in the user book.
if you have not got it try to see if you can download itdave
Re: BEKO DCU9330W 7187831300 S/N 13-203515-09
beko shows part no as 2961561501
also
from picture of board the power supply is the collection of components on the pic. look for bulging caps on the low voltage side ( small caps on right ) or you could try changing power supply chip the small chip in middle ( cant see if a 7 or 8 leg version) they are very cheap
Dave
Re: getting beko wm74135 into diagnostic mode
Close the machine door if opened. Switch to service mode. To switch to service mode, move program selection switch to CANCEL position. Then, while pressing START/PAUSE button, bring the program selection switch to the first program in the clockwise direction. Front door will be locked in the service mode.
Dave
Re: Hotpoint HULT 943 – door doesn’t open
http://www.ukwhitegoods.co.uk/search/fi … e-engineer
try here
Dave
