[electrofix]

Re: Knocking Noise Of My Miele

the hope is the shock absorbers have failed if its anything else it could get expensive

Dave

use the engineer search facility on this site to find a local trusted engineer

[electrofix]

Re: Lamona HJA4620 (double oven)

from what i can see the part you want is

263410018 cooling motor thermostat but only seems to have 2 connections but you need to check if its closed circuit with the wires off

Dave

ps if you pm me vyou email will send you Beko info

[electrofix]

Re: Door not closing, and machine not starting.

dont know about another latch but if the door closes with a push but then springs open it is normally the hinges that have been strained and bent

Dave

[electrofix]

Re: Whirlpool regulator

have checked my self no joj

but you could
post all numbers off reg plus a picture would be helpful and
someone may recognise it

Dave

[electrofix]

Re: Miele W863 Inlet light flashing

i would check pressure switch and hose for blockages and air leaks

Dave

[electrofix]

Re: Britannia cooker hood lights stopped working

dont assume if the power is not getting to the transformer it will give the same result

Dave

[electrofix]

Re: Tricity Sovereign 4638 Oven thermostat?

if you set oven at 100 and get 130 plus then its a stat

Dave

[electrofix]

Re: Hotpoint hood fan randomly coming on!

its got all the makings of an board problem. i looked on the hotpoint site and its not shown but since they are showing £21 for a supply cable i would hate to think what they wanted for a board

Dave

[electrofix]

Re: John lewis jltdc07 c/t/dryer

diag shows motor connects to terms 9.1 9.3 and 9.4 on pcb

9.4 is commom 9.1 ans 9.3 is reverse connections. it is showing a relay that changes direction and feeding that relay is a triac

got tech info if you want it

Dave

[electrofix]

Re: John lewis jltdc07 c/t/dryer

e51 fault is listed as triac fauly but it does not have to be short circuit just leaky. had one the other week on an auto washer swopped traic now ok. also the damp motor prob i have had a few times and it relates to an earth fault on the motor. megger the motor with it disconnected to look for readings

hope it helps

Dave

[electrofix]

Re: zanussi zwf16581w just bleeps

have got the manual for
model ZWF16581w pnc 91452262900
if you want some light reading

let me have your email add and i will send it

Dave

[electrofix]

Re: Miele W863 Inlet light flashing

no its more about the speed of the fill. as the valves age the rubbers split and the fill speed slows down. if it does not fill in a given time it goes into fault mode

Dave

[electrofix]

Re: Miele W863 Inlet light flashing

is it filling quick enough?

try adding water through soap draw at the same time as it fills

Dave

[electrofix]

Re: Door not closing, and machine not starting.

you now have 2 faults

fault 1 (the original one) your pump is probably blocked with glass or chicken bone or the like

fault 2 the door lock is now in the closed position. I use a wire coat hanger cut off about 6 inches of the metal. put a full loop on one end ( to stop injury) and bend the last half inch of the other end at 90 degrees. you can now hook this into the lock and pull it forward to the open position

Dave

[electrofix]

Re: Bosch WTV74105GB/13 Vented Dryer

some of those stats may well be ntc’s therefore will give a resistance on higher ohm scales

also it sounds like you have a fault code when it stops

maybe another member has a list for that dryer

Dave

[Author]

Posts