Forum Replies Created
-
Posts
-
Re: fault code EFO AEG 16830
not all EF codes will reset this way
there is 1 EF4 that need resetting by an engineer who can then check the machine for a faultas a user you will get the code EF0 but if you went into the engineering mode you will get EF1, 2 ,3 or 4
EF4 Water fill pressure too low , no signal from flow meter and solenoid valve open
This machine counts the water in with a flow meter same as petrol pumps do. if this meter is not working and the timer expects it too it will lock out to prevent flooding
Re: Bosch tub change
dont know whether tub change is possible you would have to look at hose positions etc
from previous post did you check the heater and motor
Dave
Re: Miele Novotronic T430 thermostat cut out blown
have checked nettoparts but they dont seem to have this part
Dave
Re: Miele Novotronic T430 thermostat cut out blown
ring miele themselves
part are not cheap but they will often give you the part number and you can search around but most times i just order and charge it on
Dave
Re: hotpoint aquarius FDF784 making loud noise at start
chances are there is something in the pump that needs removing
so the local guy will be cheaperprob not a novice job at hoptoint put these pump in very bad places
Dave
Re: Classi XX Bosch dish water
ther are 2 main reasons
1 The pump is jammed bits of glass etc ( as in post above )
2 Your drain hose is blocked. Get it a lot when people put fat down the drainDave
Re: Whirlpool dryer 3rler5437kq0
you can oil it but it wont last so change it is the only credible repair
these units are easy to strip not as hard as you think
Dave
Re: Hotpoint Mistral FF92S Fridge Freezer not cooling
these may be frost free but they can still ice up.
the way these work is to bring some cold air out of the freezer into the fridge to cool it down. if the ducts are blocked it fails
empty and defrost completely before you assume its anything else
Dave
Re: Bosh Dishwasher sgv53egb/10
they have to reliably open and close to count the water in
if it only fires every other one you get twice the water
you can buy and solder in the reed switches to repair them
Dave
Re: Hotpoint WT741 – test
have you tried all 3 methods
trade-technical/hotpoint-stuck-test-t12044.html
Dave
Re: Neff T1722N0/02 ( Hob)
if the rings that go off stop as a pair
could be the links in the terminal block have you checked it ?
Dave
Re: Beko OIF22100X Fan Motor Problems
if the motor is free and you are applying full voltage then its ok
some of these motors run slowly to reduce noise it could be normal
Dave
Re: Beko 8227W won’t reset
is the child lock on ?
press and hold anticrease and quick wash buttons
Dave
