Forum Replies Created
-
Posts
-
Re: awp510l
heater toc is only meant to stop fires so will only cut out if heater is out of water.
Dave
Re: Zanussi ZWD16270w1 multiple(?) problems
most dryer heaters a situated in a box on top of the machine under the lid
you should see the element tails sticking out of the box most times at the backDave
Re: Hotpoint wd420
looks ok to me qualtex car91 gen no C00201861
do a google image saerch with gen numberDave
Re: pcb for baumatic bwd1409w
quick search on connect see what you mean
one problem this model number comes under Daewoo not Baumatic
have you made mistake with model or make ?
Dave
Re: Zanussi TD 4112 W not drying
if the back is getting hot it has to be an airflow problem. if all ducts tubes and filters are ok then you need to check the fan
dave
Re: BOSCH Control Unit
although i do not know this exact machine i think it unlikely bosch would design a programmer to work on 150v. if they did there would have to be a dropper of some kind to bring the voltage down from 240. this would have to be a seperate pcb or integrated in the timer
best solution is to use a low voltage buzzer and with the plug out trace the wiring to the timer
Dave
Re: Indesit TA5FNFS Fridge freezer control card
by the looks of it it is a programmed panel and it all depends on whether the eprom is removable to swop to the new one if not then its not an easy job
2 questions
1 how old is the fridge ?
2 does it show any signs of life or is it just dead. if it is alive how does the fault show itself ie what does it do ?Dave
Re: Zanussi FLE1015W Washing machine-stops after wash
the fault code you state is not listed
light 2,3 and 4 give you a fault code in the 70’s which tend to be NTC
but if you let me have your email will send you some light reading which will tell you how to put it in test mode
Dave
Re: Bosch Capacitor Replacement
when the plate it put in is slides and locks
either the left or right hand side has to be prised up to allow it to slide
think you prise left and slide left but dont hold me to that
you may have got this wrong. normally when this cap fails the unit blows fuses. the fact it is dead may point more to a timer fault. what i would do is take the door to bits and use a multimeter to buzz through the wire from the plug to the on off switch. that way you know the power is getting into the door
Dave
Re: Hotpoint WML 520
I would send both boards to emw and ask them to test as a pair. sounds like a sofware fault as the knob tells the prog which programme to run
Dave
Re: Bosch WVTI2864gb/06
a lot of modules have a fusible resistor around 100 ohm on the main power panel and these can fail for no reason sometimes
Dave
also is model correct could not find it on bosch site ?
Re: Sarena SK312X oven stat
go into shop link at top of page
they a few parts for this model but not stat but you can email them
DaveRe: Bosch WFT2800GB/13 Washer/Dryer No Heat
dont know specific machine layout but
have you checked pcb for bad solder joint on relay if relay on main pcb
have you checked relay ie is there a dc voltage on the relay coil
Dave
