[electrofix]

andyjawa wrote:NOTE. To save anymore screw ups with changing belts from the front of the machine it is actually easier and less risky to change a belt ( regular occurrance on these ) from the rear of the machine. You really want to change the rear bearing at the same time anyway.

agree do all of them that way
you can often just sneak the belt down the back after removing most of the screws without a complete strip down

Dave

[electrofix]

if i remember correctly when a halogen ring failed they were a silly price too. have seen £120 for a new element
Dave

[electrofix]

the glass yes only a mere £1192.76

Dave

[electrofix]

well Bosch codes are never easy but from some digging am getting hits on a communication error

try checking connections between the boards

Dave

[electrofix]

hopefully a bad joint as the parts for these are very silly prices open it and remove and replace the temp sender plugs from the induction rungs

be careful its an indution hob with 300v dc power supplies and capacitors that hold charge even when its switched off

Dave

[electrofix]

well the wash light if its a fault code is fault 8 heater problem

disconnect heater, remove belt. add a pump or lamp to heater wires and see what happens

Dave

[electrofix]

everytime someone dropped them it would be back in for another plastic motor support

Dave

[electrofix]

best of luck

moved the post

Dave

[electrofix]

as long as the ring lights up fully on full power its got to be the switch

if you strip it you will find faulty contacts

Dave

[electrofix]

have sent you the service manual to hotmail acct

Dave

[electrofix]

have you got any fault codes either displayed numerically or on lights

did you chack the wash heater for earth problems also the dryer heater ?

Dave

[electrofix]

ok
you state in the title you have an indesit oven but the pictures are of both the oven and the hob

Which one is faulty ?

Dave

[electrofix]

you have to run it to make sure you know where the water is coming out of before you seal it

then use a hair dryer and paper towels to get it dry before you arr sealant

bosch do have the odd mod kit to try and stiffen the plastic to stop leaks but mostly seem to be for the right hand side only. there may be others but Bosch texh is hard to obtain

Dave

[electrofix]

assume you checked all 3 spray arms

there is one on the roof just for the top cutlery tray

Dave

[electrofix]

check the drum springs
if the whole drum unit has dropped its about the only thing it can be

Dave

[Author]

Posts