[helo_75]

pcb it is, you can check for a live to the pcb…..

youll need an eprom/smart card too

[helo_75]

yes u will need a new one (eprom), unless youve had a pcb before, and casn swap iit over?

a pcb for £29 where from?

[helo_75]

Re: FF92P mistral f/f

chippy1970 wrote:Update—– Hotpoint should be called NOpoint

The fridge gave up again so I have now bought a new Bosch to replace it.

So far in only about 7 years we have gone through

3 hotpoint washing machines (one only lasting a week)

2 Hotpoint tumble dryers

1 hotpoint fridge freezer

Will never buy Hotpoint ever again what absolute rubbish 👿

youve done well

what possessed you to persevere with 6 machines?

[helo_75]

its dead easy mate, just use your common sense

lets just say, the wire to the thermal fuse has a white cover over it, the rest is fairly obvious

[helo_75]

under the lid, next to the timer…. bit fiddly, plug out when looking and make a note of where the wires go

[helo_75]

not sensing pressure switch

if your lucky, it’ll be just that, but experience would suggest a faulty pcb

[helo_75]

its the relay thats faulty!!!

c ommon problem…. available in the online store

[helo_75]

here we go…..

[helo_75]

if its getting hot, yes the power is there, so a new pump should cure it

good luck

[helo_75]

one side of the hinge pin , on the trim, is moulded closed, the other open , i reslly dont see how your struggling tbh……

[helo_75]

honestly, if you move the hinge to the closed position, it will slide down and pull out

look at it, its really obvious

[helo_75]

its a what armature?

brushless motors are rare these days, be carefull what u choose

[helo_75]

maybe theres something in the way… these guys are only trying to help!

maybe theres a shelf not fitted right.. or the usual pop bottle catchin on the door rack?

how on earth would the cabinet twist?

[helo_75]

omg stripey, u really are a goon

u make yourself look more pathetic with every post

do you think the poster would have asked the question, after possibly 2 years if he didnt think there was a problem?

the light WILL NOT flash in the off position, which, funnily enough, is when the machine should be off

[helo_75]

there is another thermostat

inside the door, at 12oclock, in the plastic housing…. 2 screws, just be gentle, and wiggle it out

other than that, its the pcb (if its the model with a pcb)

[Author]

Posts