[helo_75]

i got a wiring diagram here if you give me your email?

[helo_75]

is it single cavity?

is there a door switch on it?

[helo_75]

blind leading the blind

thats not the pressure switch, its a breather hose

the whirlpools have the pressure switch at the front, usually above the door seal

oliver, what DO you do for a living please?

[helo_75]

http://www.comet.co.uk/shopcomet/produc … O-WME8227W

is not a bad buy by any stretch

but , agreed, its better to spend more money

like

http://www.comet.co.uk/shopcomet/produc … WAA24270GB

[helo_75]

nah, its pcb failure

its been well documented

[helo_75]

and youll b e right

i take it youve cleaned the sensor bar first?

[helo_75]

theres 3 mods for that

takes ages to defrost it
if its fully defrosted. 2 screws and it pulls out easily

will require heater plate, drain heater and pcb

[helo_75]

what they do do is fill from the prewash valve for a few seconds, self test, then switch to the other valve for filling to level
hot valve on that is only used for topping up

i tend to swap the plugs over to confirm! they do push in if you push hard enuff

i had one of them, just yesterday and that was the valve, only that was because the board was faulty, and it had burned the valve out cos it was constantly on

gotta love em

[helo_75]

its f11- machine fails to activate pump

if its pumping, its deffo the pcb

[helo_75]

id still be checking the valve

but then its probably the board, cant rule anything out on one of them

[helo_75]

hows about advising the right thing?

light 1 is f08

heater relay on pcb sticking

worth checking insulation on heater and/or pressure switch

money is on pcb failure. requiruing pcb and smart card , card differs depending on tub and motor fitted

and a reader to programme

or emw cxan supply a replacement

and gandhi.. how can you advise on carbons when it

a > isnt the fault
b > has either a ceset/fhp motor or 45mm/. 52mm stack?

nothing to do with the brushes im afraid

[helo_75]

p/no c0085194

yes it will probably cure your problem

quick email to the online store will get you one quicly

[helo_75]

ok, so looking at it ‘logically’?

the outside spring appears to have no function?

doesnt look right to me, but its hard to tell from a pic, isnt it

[helo_75]

have you fitted the new heater box with the spiral element? the earlier elemnt was a nightmare for going down

saying that i change a lot of the spiral type too

[helo_75]

have you looked at the writing on the wires 😉

[Author]

Posts