Forum Replies Created
-
Posts
-
Re: Indesit WIA101 – aborting wash
hi, think you need to check which ones are flashing, the anti-crease is the 1st one (left to right) and wash is again the first one (top to bottom)but this is not a listed fault code
However if you find that it is the anti-crease and Rinse (2nd down) flashing that would be a pressure switch not sensing fault, (p/sw, wiring or module)Re: Indesit WIL163UK Strange fault???
hi, did you check both inlet valves? they can fill to a level from one, then switch to the second valve, but if its o/c it will just sit
Re: Haier products
I really dont get all this bickering, sure there are some poor comet guys, but there are some good ones too, same as every service agency, and independants, what i dont get is all this WE are better than YOU stuff, we’re all meant to be on the same side here
Re: WF240 stuck on wash
hi, chances are that the heater has failed, easy to test from the rear with a test meter, Please make sure the plug is out first though
Re: Hotpoint BFI620 Door Seal Leak
Hi, no need for a new seal, you are right that it is only a splash guard, your problem is the powerball tablets, they are too strong (especially if you are in a soft water area), the excess detergent is causing the foam, when the correct dosage of detergent is used the machine will produce no foam, there are loads of posts on here about the problems of using these tablets
Run the machine on a few short cycles with nothing in it and the excess detergent will soon go, then switch to using basic tablets,
Re: Whats the most annoying thing customers do?
bbrring bbring,
me ‘hello’
her ‘hi, i have a creda dryer that is getting hot but the drum is not going round’
me ‘no problem ill pop round later today’
her ‘oh thats great, thanks’
….
…
…
me ‘hi come to look at the dryer’
her ‘oh thanks so much for coming, its over here’
….
her ‘my husband had a look and says the belt has broken’
….
me ‘ok, so where is the rear fan, fan cover, bolts, heater, wiring, back panel, rear pin, sides, and 30 screws?’
her ‘oh they are all here, and here is the jam jar with all the screws in’
…
…
me ‘ok then, when ur hubby has put all of it back together ill pop back & fit the belt if you want!’Re: hotpoint 9546A
yeah the indesits need both back & front half together, bit like the zanussis, but the origional 9546 will just need a bit of persuasion, it may look a few mm out, but it will fit
Re: Whirlpool ADP5962
yeah but by the looks of the pic your only going to get an empty box delivered, at least mine will contain a fan oven motor 😆
Re: UK service repair manual factory site?
and still i ask why i stay here & not move to the US 😆 low tax, low house prices, cheap gas, and now free service manuals 😆 😆 as long as it still rains more there than here i guess ill stay!
