Forum Replies Created
-
Posts
-
Re: No power on Hotpoint ultima WT761G 57250489
In most cases this is indicative of a failed main pcb. 🙁
Re: INDESIT IDL 700 UK Not starting
Lights 1 + 2 signify a drain time out, possibly an obstruction in the drain pump.
Re: Suppliers in Australia.
Hotpoint carbons a bargain now, only £31 as opposed to £3.00 trade in UK. 😯
Re: Suppliers in Australia.
The only thing I know about spares in Oz is that they often have an eye watering mark up. I have seen Hotpoint 1600474 carbons listed at the equivalent of £60.00. :eeek:
PS. Surely you mean emigrating ?
How is your Fisher & Paykel knowledge. 😉
Why not post your question HERE
Re: You know you’re getting old when…..
Will be missing this meeting Bob, family wedding in Cornwall so taking a week off, to far to go for just one day.
Re: You know you’re getting old when…..
I must admit I am getting that far more often these days. 😆
You have to start worrying when you get one like I did a while back.
Customer said she had mentioned to a friend that I was calling and she replied ” Oh, is he still alive “. 😯
Re: Hotpoint BWD129 Flashing lights 5,7&8
1,2 + 4 = F13.
Drying NTC open/short circuit/fan motor jammed.
1 + 2 is a communications error.
Re: Hotpoint BWD129 Flashing lights 5,7&8
5,7, + 8.?????
Only four lights used, the right hand column of lights/buttons.
Possible you mean 1,3 + 4., which is F11, ‘pump cannot be activated’
Will the pump run when set to spin, drain out all of the water, take out the filter and look inside to see if the impellor is going round.
Re: ISE 10 1607 cutting out/sticking?
Thinking back wasn’t there a tech bulletin or memo about a suppressor change not long after the 10 went on sale?
Re: ISE 10 1607 cutting out/sticking?
timdowning wrote:Mains socket, moulded plug, breakdown in suppressor?
Great minds think alike, those are the areas I intended to look at first on next visit Tim. Will update if I find anything.
Re: Hotpoint Aquarius WML760 – stops during cycle
When all of the horizontal lights flash you need to make a note of which of the right hand vertical lights are on steady. These lights give the error code, the bottom five vertical lights including the door locked light are used and are numbered from 1 to five from the bottom up counting the door lock as No: 1.
Re: HLV241 Button 4 flashing
Wrong model number, should be HVL241, 😉
1 & 2 flashing is a communications error, 4 flashing is F01 motor triac short circuit.
Could just be poor motor plug connections, worn motor brushes or main circuit board failure. 🙁
Re: Need advice on buying a vent hose
It is as I thought, although TBH I have never even noticed the had the spirals going both ways, you learn something every day. 8)
