Forum Replies Created
-
Posts
-
No service manual available but I can give you some advice on how to do it the 6 screws need to come out t20 then the earth wire behind and the wires need to be removed I’ve attached pic of 1st step,try and follow the steps in pics I’ve circled and arrowed most screws that need to be removed when you remove all the electrical components there is a metal bar that needs to be removed you use a pliers and pull it to the left to release it and then back to right to remove it then you should be able to access the fan which is held on with 4 screws. Hope this is some help to you kai.
Tell her to go back to bosch ad if she wad only a month out of warranty the repair would be done free
Ok test programme for this is make sure door is closed turn the dial clockwise 8 positions press and hold button nearest to dial and turn to position 9 release button and it should show errors if any and should show p09.
turn the dial anti clockwise start at position 1 this is test for motor and fan
p2 is the compressor test need to check that it’s pulling about 350 within the test
P3 is pump test and that’s all you can test, hope thus info helps this applies to most bosh Siemens dryers
kaiAs this is a built in unit 1st thing I would be checking before you go changing parts is the install especially as its been there so long must have moved and need re fitting
kaiDoes sound like maincontrol module part number 11014344 I’ve had main do this and that part number is for the pre programmed one
Another reason for the magnetron failing could be using full power to heat up everything as full power on these microwaves are on for heating liquid
The e07 fault is either door lock or wiring, possible motor if it fails pat test or inductor on main control board
