[kaibart]

I would check the heat exchanger unit to see if that is blocked up as I’ve changed pump for e24 and it ended up that the heat exchanger was blocked changed that and haven’t been back since

[kaibart]

And the odd selector switch that goes faulty do it aswell on a old model neff

[kaibart]

Well it depends on wash programme you use and load size as the detergent in the tabs can’t be cut in half if your using a small load as regards to the dryer it maybe a broken wire.
washer dryers all have problems regardless of make , other makes might not have the problem of leaking but will have other issues I can’t recommend 1 but I’m sure someone else on here can [USER=”125″]don[/USER]

[kaibart]

The bloomberg washer dryers are made by beko and are normally sold by local independent shops if you have a leak and it’s normally water coming from the left hand side or under the appliance this is usually due to liquid detergent or liquid tabs being used at a high temperature wash higher than 30 degrees and with laundry that generates more sudz like towels or fleece throws, try using powder and you won’t have the problem

[kaibart]

Yes you drill them out and fit the suspension peg that is supplied

[kaibart]

The door switch is normally on the left hand side and the hinge activates it so left hand side panel needs to come off

[kaibart]

How long did you leave it for before you knocked it off as sometimes these take a while to start if it’s doing the regeneration

[kaibart]

Or alternatively you could just drop the tablet in the bottom of dishwasher and not worry about it

[kaibart]

Check the dispenser then as the fault relates to these 2 components

[kaibart]

I had one fail yesterday and it filled and started to wash after a few minutes the check water light came on so start with contact flow through sensor

[kaibart]

Think your not looking in the write area e19 is normally the drain valve heat exchanger valve faulty

[kaibart]

I would check contact, flow through sensor then drain valve

[kaibart]

You have fitted the wrong heater as the part number I get is 40005010 and it doesn’t have a re settable stat on heater

[kaibart]

I mean 1 ohm across both stats on heater front ntc resistance will be different will be kohms up it will rise or fall I can’t remember

[kaibart]

You should have about 1 ohm on heater and front ntc when you measure it resistance will move high or low can’t remember full it this happens ntc will be fine more than likely to be pcb then

[Author]

Posts