[kaibart]

What heater have you changed it for does it have a selectable stat if so it’s the wrong heater as the had trouble with thus and changed the rating of that stat on new heater to 200 degree’s

[kaibart]

I’ve got hotpoint engineer come out tomorrow I will ask him and report back for you

[kaibart]

I would read the manual this sounds like a heat pump dryer that’s telling you to perform a clean for the condenser

[kaibart]

I would check for earth fault on heater failing that it will be valve or pressure switch

[kaibart]

E43 is a motor 3d 3g sensor blocked drum caused by laundry, motor is blocked this is what the error means

[kaibart]

Yes I would say a relay fault as I’ve done a few and I hear the relays clicking alot

[kaibart]

I agree with dave probably the pump area is full if fluff and gives bad reading as dave has explained

[kaibart]

From trying to remember the 2 green wires go to the door lock so sounds like wires are earthing on cabinet take the front panel off and take a look kai

[kaibart]

That’s a power board fault programmed part number 10017495 expensive though £206.62

[kaibart]

May also be worth checking the from fan isn’t clog with fluff to

[kaibart]

I would check k the pump for any restrictions and you will hear pump run

[kaibart]

No it’s 2021 add 20 onto 01

[kaibart]

Take off the fan motor and clean the fins on the fan blade when it’s off use the inlet hose to give condenser a bit of a clean

[kaibart]

This is info on f09 Hope this helps

[kaibart]

As long as the live and neutral and earth are correct polarity it should be fine

[Author]

Posts