Forum Replies Created
-
Posts
-
Have you checked the lower spray arm isn’t splut quite common fault on smeg the only other thing is if the cabinet is twisted due to poor installation
The error code failure is on bekos website water inlet valve/pump running continuously, solution check water valve, valve triac faulty
The hotpoint capacitor is a 8.5 from memory so either a 8 or 9 will be fine as I know the newer ones are 9
Yes it should do but there may well be a restriction in the heat pump these dishwashers work on the following drain pump runs briefly heat pump runs briefly small amount of water in then a pause then same sequence but heat pump has 3 different speeds to go thou then it will start to fill and go through wash sequence, just wondering the new pump was it in a brown box or in a bubble wrap bag?
Ok so let’s start at beginning what was the part number for the drain pump? It should be 00631200 there are pumps that look the same but don’t fit, and for it to drain the heat pump needs to run briefly to let the drain pump there is still water in the tank, Part number for heat pump is 00755078. Also the machine that you had a spare pcb off must have a fault
I would be checking front bearing pads and there is a tech bulletin for the position the belt needs to be on the motor I haven’t got access to tech but maybe dave has regards kai
With this fault it can be a number of things so might be worth getting someone to check it over as could be door switch could be any number of tocs and maybe pcb
