Forum Replies Created
-
Posts
-
Re: Candy Alise GOW475 stain blaster fault
Could be error code 12 which you can do a search for on the site I know you say the light flash 12 times but what function is the machine not doing (not draining )for example
Re: Curry’s pull out of Whirlpool drier exchange arrangement
I think currys must have agreed a deal hotpoint as I have 1 of these dryers and the e-mail said currys drop off and collect new was ending soon
Re: Hoover VHV680F rear bearing
Hi I would suggest buying all parts separately will be cheaper they do a heater support assembly but is very expensive
Re: Candy EVOW6853D-80 PCB Part No
No the original is a dc module and the 1 they have supplied isn’t try the part number from previous post that a dc module and the 1 you want
Re: Logik Washing Machine l612wm15 fault
If you are not satisfied with machine as for a replacement you don’t have to have a repair done if if only a few days old
Re: Candy EVOW6853D-80 PCB Part No
As this machine is a dc machine it will either have a separate rectifier with 1 lead going to it or will have a dc module with the rectifier built in if so the part number is
49023647Re: Candy GOC58F no heat
The front panel comes off and its located towards the bottom of the appliance.
Re: Hoover DYN7164 310051781227 motor stammer
You have checked the plug connector to the motor for a wiring fault if so definitely go with module
Re: Hoover DYN7164 310051781227 motor stammer
Change module this will sort it for you connect have them in stock 5045382391334
Re: hoover dyn9144d2x
No fit the correct heater otherwise the electronics don’t like it Kai ex Hoover engineer
Re: Hoover DYN7164 310051781227 motor stammer
Check rectifier common to go due to overloading if the tracks are ok inspect main pcb or burn Mark’s hope this helps normally more than 1 problem with these dc machines thou.
Re: Blomberg BEO9414X Oven fan motor
Try this part number see if it’s the fan motor you want most common ones used on beko ovens BEKBE264440102 qualtex do pattern 1 to mtr308
Re: Hotpoint wmfug742 trips rcd
3 main suspect part the mains lead and filter where it enters the machine the main drive motor or the heating element to check if the element or motor remove mains plug put insulation tape on the spade connects unplug 1 at the time to see if rcd trips if it stops with 1 of these unplugged you have found your problem hope this helps you
