[Lawrence]

Re: Kenwood CK 405 Range Cooker

yep secured from behind ,isolate at supply and pull out remove the back panel and there will be nuts on the other side of the studs you can see from the cavity

[Lawrence]

Re: Hotpoint Tool Case 19

we use the Parat 433000171 ,find it on google ,prices vary

[Lawrence]

Re: Cda wd 140in error inadequate water supply

blocked pressure system,faulty pressure switch ,hole in pressure hose, if its overfilling it could be any one of the above

[Lawrence]

Re: Samsung DV70F5E0HGW

There is a reset procedure ,but HE is normally the pcb or circ system or sometimes both.
Either way mega bucks

[Lawrence]

Re: Samsung DV70F5E0HGW

its a heat pump dryer so it doesn’t have a heater .
If it has a fault then it should throw up a fault code ,if your customer is complaining of poor results make sure the condenser fins are clean.

[Lawrence]

Re: Samsung WF431ABP

is it “Glugging” and coming down the front or seeping around the edges of where the disp top seals to the bottom
if it Glugs change the disp to tub hose as its not venting itself as it fills
if its seeping then take the 2 sections apart and seal with Debor

[Lawrence]

Re: samsung WF431ABP

2

[Lawrence]

Re: smeg built under double oven duc04ss

There should be a pair of pins that came with it ,look for a hole in the hinge ,put pin in and it locks the hinge as you remove the door
If you can’t find the original pins then use rivets or nails

[Lawrence]

Re: Whirlpool to do a recall on Hotpoint dryers

I had someone phone yesterday with an Indesit condenser dryer who didn’t know a thing about the safety recall, she was amazed when I said it had been all over the media

[Lawrence]

Re: Thoughts on what leave will mean to us?

Bit off topic but I’m more worried about the amount of product that comes out of turkey

[Lawrence]

Re: samsung wfj145n inlet device

its a flow meter and the part number will be stamped somewhere on it

[Lawrence]

Re: engineers meeting

Hi Pete
Due to a combination of the hotel capacity being low (12 rooms available) people having personal and business commitments ,declining numbers and the time it would have taken to organise another venue it meant that it wasn’t really viable this year , so the decision was made to put all effort into the Feb meet which is Fri 24th 2017.

[Lawrence]

Re: Problems Finding Replacement Oven Due to Sizes, any idea

What make and model is your original ?

[Lawrence]

Re: Flavel Milano 60 Glass Hob Lid Springs

They are very easy to fit but ensure they go in correctly handed right to right and left to left.
Slot the ends in the key way in the bracket and the Spring is already pre tensioned

[Lawrence]

Re: Broken Hob Glass – Cracked Whilst Cooking??

you may need to email them a disclaimer advising that you have advised not to use it due to potential water ingress

[Author]

Posts