Forum Replies Created
-
Posts
-
Re: Removing Zanussi ZCG661GWC glass lid deactivates gas saf
Because the combined output of all 4 burners does not exceed 12.6kw the minimum height to cooker hood can be as low as 650mm.(see my previous post and the Zanussi User Manual page 18).
Minimum height for gas hobs with output exceeding a total of 12.6kw then the height is extended to 760mm
Removing Zanussi ZCG661GWC glass lid deactivates gas safety?
What is the gap between the burners and the cupboards directly above?
The illustration illustrates what Johnmac was referring to.
Samsung WF80F5EOW2W ECO-BUBBLE
They devour hankies and don’t ever think of using Dylon Colour Catchers in there! 🙁
Motor help
Just tilt the machine and fit brushes with motor in place. It does hang on lugs though if you insist on unhooking it.
Re: Bosch dish heater Do they match
Gandh1 has it the wrong way round. Your stock heater will fit just fine. Just ignore the fact it has a Turbidity sensor, you can’t connect that anyway.
BOSCH WASHING MACHINE WAP28360GB/14
blackandwhites wrote:If the pcb needs to be replaced,does it need to be reconfigured?
Neither the Power Module or the Inverter need configuring. The Inverter more likely to have failed than the Power Module. ( I’ve no idea which “pcb” you refer to?)
Re: Bosch Neff Siemans
don wrote:You’ll be lucky :rolls:
Quite so 🙁
Whatever did happen when white goods trade associations tried to lobby parliament into implementing ‘White goods block exemption’ anyway? The motor trade succeeded many years ago and the independent trade has benefited ever since.
Unfair practices in the white goods trade affects far more people than the motor trade. And the industry has run roughshod with their unfair practices for more than two generations all the while.
Too little has been done too late I suspect. Too many brick walls and no bulldozer.
You can get tech info from BSH but you need to know someone within in order to get it. The trouble I found was that sharing that information here on UKW meant it immediately got published in the public forums and hence into the public domain seconds later. Vital trade only stuff leaked meaning the independents suffered.
So, in effect we have the devil or the deep blue sea. If the manufacturers were forced to give the trade full tech information/co-operation to approved independents that same information would get onto the Internet public domain in an instant.
BSH employees will get instant dismissal for sharing info, likewise will many of their competitors employees. So from now on in technical stuff will be harder to obtain. And if you can get any info then my advice is to think carefully before sharing it with others on the Internet.
Re: Neff intergrated washing machine fault code
What’s the insulation reading? Motor and heater especially?
Re: Appliance Brands
The link below us a little dusty as it was compiled ages back but might help you…..
http://www.ukwhitegoods.co.uk/help/abou … ation.html
