Forum Replies Created
-
AuthorPosts
-
February 3, 2015 at 6:11 pm in reply to: ISE10 washing machine broken- is repair possible now ? #424274
Martin
ParticipantRe: ISE10 washing machine broken- is repair possible now ?
I reckon you could easily get 99p for it on eBay and not be troubled with having to take it to the tip. 💡
Martin
ParticipantRe: Bosch WAE24368GB/54 – not starting
Are you sure the delay timer (aka the ‘Ready In’ button) hasn’t been set by mistake?
February 3, 2015 at 10:09 am in reply to: Dangerous engineers , is there nothing we can do about them? #424298Martin
ParticipantRe: Dangerous engineers , is there nothing we can do about t
nigegt wrote:Self regulation is key. That’s where WTA and DASA come in.
I’m sure the cowboys and incompetents of this trade would have little or no obligation towards “self regulation” in pursuance of their daily activities. Besides pledging the oath of allegiance to a trade association does little or nothing in warding off the inept.Cowboys rarely survive long though many learn by the trail of past mistakes. Given Simon’s example of the employee from hell going on to work for both Siemens and BG leaves us wondering if he ever learnt from his cock-ups? Probably not, who knows?
I Googled up and found that someone with no sense of smell suffers from ‘congenital anosmia’. I seriously doubt any potential employee who ever be asked if he or she is a sufferer as a prerequisite to getting a job. In my day you only had to pass the colour blindness test in order to do this type of work and I doubt even that is a requirement these days.
Martin
ParticipantRe: Hinges for NEFF B186IN2GB/05 FD8311
No at all. With the door removed and side panels removed its easy enough.
Martin
ParticipantRe: Bosch fill and drain on second fill
The Impellor Jug (part no 00424099) needs replacing.
Martin
ParticipantRe: Hinges for NEFF B186IN2GB/05 FD8311
Replace receivers
February 2, 2015 at 11:22 am in reply to: Advice on space needed around washing machine/washing dryer #424324Martin
ParticipantRe: Advice on space needed around washing machine/washing dr
With just .5cm that is tight. Not much wiggle room at all so you will have a job getting it in and out!
Martin
ParticipantRe: Remove seized cooker door
Soak overnight in WD40? 💡
Martin
ParticipantRe: Bosch Ecologixx 7 dryer – no or little heat
Transporting it on it’s back could well have caused oil to get into the refrigerant and render the heat pump system useless. (Especially so if the appliance was used within 24hrs of it being placed upright). You are best advised to contact the removal company and inform them the machine was damaged by them. (Their liability insurance should cover such mishaps).
You, or they, will then need to contact BSH Appliance Care and get them to fix it.
Martin
ParticipantRe: Detergent use in hard water area
Don’t you think the heater failure the issue rather than the detergent?
Martin
ParticipantRe: AEG l61271WDBI
Dryer element, inlet valve or NTC. All the usual suspects.
Martin
ParticipantRe: Heard it all now!!
He’ll pick your brains then buy the spares from eBay and you’ll be lucky to get a “thank you!”
Martin
ParticipantRe: Electric ovens leaking!!!!
Often created by lots of moisture content in whatever is being cooked. For example: roasting potatoes, frozen chips, baking apples. Even grilling bacon and tomatoes where the door has to be shut can produce a lot of excess moisture with nowhere to go but run down the door glass.
January 29, 2015 at 6:20 pm in reply to: Bosch WFF2000GB/01 Constraints on replacing carbon brushes #424158Martin
ParticipantRe: Bosch WFF2000GB/01 Constraints on replacing carbon brush
1) Compressed air
2) Hand tight, not necessary to use torque wrench.January 29, 2015 at 2:48 pm in reply to: Bosch Classixx 1200 express – Stopped working, no display #423703Martin
ParticipantRe: Bosch Classixx 1200 express – Stopped working, no displa
MagicMeg wrote:Hotpoint/Ariston 9kg model, just out A+++ ratings all round.
Perfect!
-
AuthorPosts
