[Muv]

Re: Servis M9503W washer-dryer dead

Don’t check anything with power connected. Zap!

[Muv]

Re: Servis M9503W washer-dryer dead

Have you got continuity from your live & neutral at the plug, to either side of your mains suppressor..?

This is attached directly at the end of the mains cable… If not there’s your problem…

Martin

[Muv]

Re: indesit wixxe127 – F05

As above reply.. Also resistance is mormal when turning..

M

[Muv]

Re: indesit wixxe127 – F05

With the power off at the wall.. Put your finger in and poke around the inside the pump moving the fins of impellor as you do so….you may find somthing that may be intermittently fouling it ….

If not its time for a new pump

Martin

[Muv]

Re: indesit wixxe127 – F05

You may have a blockage in the tub hose (large hise leading from the base of the tub, and entering the pump)
Also check that the impellor of the pump is firmy attached. This may be spinning when no water present, but it may actually be loose..

Martin

[Muv]

Re: SMEG DWF44SS.1 door switch

If the switch tested out ok, then your problem lies with the part that activates the switch, and nit the switch itself

[Muv]

Re: indesit wixxe127 – F05

Have you checked the waste pipe outlet under the sink? If you can take the pipe off, then set machine to drain.. Whiks holding pipe in to a bowl,you will then to see what, if any,flow of water you have leavin the machine.

Martin

[Muv]

Re: What was the best machine ?

Nice machine! And the old hotpoint fridge next to it?

[Muv]

Re: indesit wib111 big bang on final spin slow down

Take a look underneath the drum, you have two “shock absorbers” 1 either side of the drum, I think one of these is probably broken in some way.. If this is the problem, it’s repairable …

Maetin

[Muv]

Re: weird fault beko washer WMA642W

When you say it happens 10 seconds before fill stops, is that when the drum start turning?
Maybe it’s the revolving drum that’s forcing it back up through the draw…

Martin

[Muv]

Re: Hotpoint wd420

Dohh! Silly me..

I can now see why they looked different to the new ones..

I had removed the bottom piece on the one I used for the photos ..so they were missing the little pieces either side of the brush…

Martin

[Muv]

Re: Hotpoint wd420

Doh! Silly me
I can now see why they look different.. I had taken removed the bottom of the one I used for above photographs, therefore it did not have the small side pieces either side of brush ….

Martin

[Muv]

Re: Zanussi WJD1257W Washer/dryer pumps & fills

PCB sounds like the culprit

Martin

[Muv]

Re: weird fault beko washer WMA642W

Machine not level?
Soap drawer housing not correctly installed?
Inlet pipes mixed up. (long shot)

Water pressure to high at tap?

Be interesting to know what this problem is!

Martin

[Muv]

Re: hotpoint wmf540 door issue

Try tightening up door lock connectors on PCB, had a few with same fault..

[Author]

Posts