Forum Replies Created
-
Posts
-
Re: NEFF dishawasher notusing any Salt
Use a test meter to check if the coil has a circuit through it.
Nige
Re: NEFF dishawasher notusing any Salt
Could be a faulty solenoid on the regeneration unit, only way to check is to put a meter across it. Is wash perfomance poor? If not then the all in one tablets are the easyest option.
Nige
Re: prima (whirlpoool) dishwasher
Sounds like the pressure switch pt.no. 5031682990384 on connect. Or i’ve had them do this when the filter and spray arms are blocked.
Nige
Re: problems with IGNIS ADL 349/A/1 (I did search the forum
If you have run it with the spray arms off and it still does it then it’s prob the wash pump that is at fault. (not uncommon) It’s around £200 for the part if that is the case.
Nige
Re: Whirlpool ADG644 not heating
Broken wiring in the door very common on these where it constantly bent and straightened from opening and closing the door. Take door panel off and examine each wire and repair as necessary.
Nige
Re: Diplomat 8332 problem
Check that the start light is flashing cont. and there is no one second gap as this is a fault code so count the flashes and post again or if there is no gap then the ntc is faulty.
Nige
Re: Whirlpool top loader
If clutch and coupling o.k. then prob gearbox. Take the gear box off and remove the top and see if the teeth on the big white plastic cog are worn.
Nige
Re: September 2011 UKW engineers meeting
Saturday is best for me, no work on sunday! Hulls quite central don’t you think? 😆
Re: Fisher Paykel Dishdrawer
Been back this morning to look at this and it stops at 60 mins and after heating and wont move to the rinse, cust said if left it will just wash ’til the cows come home. Could this still be a dodgey heater plate? No fault code and non stored either.
Nige
Re: Whirlpool ADP8000 Dishwasher FB fault
Could be wash motor being slow and crap on start up, Had this a few times which is then followed by f3 heater fault through lack of water flow.
Nige
Re: Fisher Paykel Dishdrawer
Ok so changed upper loom a it lives again! But wont go through a full wash, Goes about a third through the cycle and holds but no fault code. Help!
