Forum Replies Created
-
Posts
-
Re: Miele 75 dishwasher
Maybe split lower spray arm. Or a problem with the arm anyway. Run it with the lower arm removed to see if that stops the leak.
Nige
Re: Baumatic BT2760ss lower oven element
The plate under the element is screwed from the back and it drops down into the warming/storage drawer. You have to unscrew the terminal block as the screws get in the way of dropping the panel. It’s supported on a lip at the front which is a pain to relocate from what I can remember.
Nige
Re: Ise AW23
Same as zanussi not sure on pt. no. but connect cbn9041 is the pattern part no or homespare 9894.
Nige
Re: F&P Dual Drawer – Top drawer takes forever to finish cyc
Could be a problem with heater on it’s way out or draining issue caused by a blockage or faulty rotor. Try swapping the rotors to check if this cures the issue first then look towards a heating problem.
Nige
Re: Dishwasher Not Cleaning Properly
There are several different part numbers for these but they all start with K9………
Re: Lamona HJA8514 element
Might take some searching but you will find a hoover heater to fit. It will be about £15!
Re: drum not turning on Bosch Classixx washing machine
Almost certainly motor brushes. Nice simple job too. Take the motor off and they are just clipped in. (A yellow wire to each) Plenty of tubetube vids on these for how to if you get stuck.
Nige
Re: Hoover condensing dryer HNC382-80 – anyone had this prob
Funnily enough yes and it was the p.c.b. Runs one way for 10/15 mins then stops dead. (At the point where it should start reverse tumble) When you fit the new board you’ll see it stop and reverse at that point.
Nige
Re: Clothes never gets rinsed properly
Plus if water comes up in the sink your sink drain must be restricted and so when the machine moves on to its next stage some of that water in your sink goes the easy path back into your washer.
Re: Whirlpool ADG7560
When the dishwasher faults the start led will flash a number of times to give a fault code. There will be so many flashes and a one second gap then it repeats. Three flashes is a heat fault.
A good place to start first is the wiring in the door where it comes through from the base up to the module. Often it is the heater wire that breaks.
Nige
Re: Miele W844
Try ebay. You can send it away for repair 🙂
Re: Indesit IWE81681 – No Hot Water
Heater faults pretty common. It would cost more like £100 to call Indesit though. Try the find an engineer search on here and you might get the job all done for 60ish.
Re: Hotpoint WF310 All Lights & No Action!
Very straight forward. Two screws hold each black plastic brush holder onto the back end of the motor. Tip the machine back and they are serviceable from there. 🙂
