Forum Replies Created
-
Posts
-
Re: Zanussi ZJ 1218 PNC 91451090000
i have been out to fit one of these boards today fault dead and the board with a burn mark through it fit new board but still dead so prob front pcb faulty as well.in the box was a note saying do not connect the i/r 3 wires and there was yellow tape across one of the places where the grey wires from the switch goes does this mean not to fit this one if not what is the i/r 3 wires? any help appreciated.
wd440
hi i pinch the edge connectors on board and it has cured many faults inc one last week for a friends mam with this fault and all has been well since worth a try.
Re: samsung F/F fault
not on me look back through the search under rs21 they are the same sensor dont forget to disconnect bottom heater when metering main heater as they are wired in parallell.
Re: samsung F/F fault
it sounds like a problem on the defrost side just meter the o/load heater etc and it should show an open circuit.i always replace the def sensor yellow wire as they are prone to fail as for the blue never changed one.
Re: ctd00p
thanx for reply do you also get no heat as well with the fault in the past when you have changed the timers?
Re: Late model servis burning of module
it is recomended when changing the board to fit individual spade connectors very common fault.
Re: Electrolux late model pcb’s blowing
i also have an aeg built in the cust used it fine went to put another load in and it was also dead,as for the inline fuse why bother when the boards only cost about 7-10 euros to produce and it keeps stock turning round.
cheers chris
Re: lg wd14123rd
but if it was bearings it would make a noise turning by hand but it is sound as soon as it tries to turn empty it makes a terrible noise.
Re: SAMSUNG Washer Q1435VGW no motor action
yes helo at the bottom corner the newer samsung are at the top,the older ones with the board orig poster is describing is at the bottom or every one i have changed the machine must have been upside down!!.
