Forum Replies Created
-
Posts
-
Re: Miele Honeycomb Care W460 – Unclean! Unclean!
Is it just as simple as that the conditioner dispenser is blocked up & not syphoning correctly or that machine is not level? Take out drawer, remove condtioner syphon & clean.
Re: Miele G646 sc + Inlet/Drain” indicator
Does circulation pump ever start? Could be blockage in impellor of circulation pump. Machine is looking for pressure switch activation after 10 sconds i’d reckon.
Re: Miele KF3855S-6 fridge freezer board keeps resetting
My Miele F/Freezer is the type with digital display & controls along the top. When the door is opened its normal for the display to go bright & dims down gradually after door is closed again, it sounds to like theres a fault somewhere in the sensing of the reed sw’ or the magnet on door that activates it. If the fridge door the is left open for a long time on mine the light in fridge shuts off automatically. Its worth trying a magnet to activate reed switch to see if it works. Check cabling back to board & connections to PCB. Miele refrigeration products are mostly made by Liebherr if thats any help for cross reference of spares etc.
Re: AEG 50750 VI fill valve
Re: Miele W864
Most Miele motor end plates come off the motor, front comes off machine to get access.
I’ve done some by tipping them back & working from underneath.
The carbons are unique to Miele your not likely to get an other one that will fit, also the belt which must be replaced with a genuine one as they are electrically conductive believe it or not.
Re: Miele Dishwasher G692sc+3
Sounds like you need a new on/off switch then, your local Service Engineer should be able to do it for you.
Re: Miele G646 Dish Washer
Circulation pump motor obstruction most likely, its overheating. You can take it out easilly & dismantle it to see if theres something fouling the impellor.
Re: Door seal lip repair?
Have put pattern ones on Mieles but they’re not the same quality & don’t last. Tears on the bottom door seals are common with them i find though for some reason.
Re: currys
Hope this is some help
CURRYS
RUSHMERE SHOPPING CENTRE
CRAIGAVON,
COUNTY ARMAGH
N IRELAND
BT64 1AA
Phone: 0870-609 7341
Fax: 028 38346196Re: AEG 57700 Dryer
leavemetogetonwithit wrote:Had one of these to look at the other day. Nothing holding pulley on except self-centring. That wasn’t the problem with this one though.
When you put it on any auto-dry setting it packs in after about 20 seconds and the “clean filter” and end lights come on. Seems to work OK when you set it to a timed drying programme though. Needless to say, all the filters, condenser, etc are perfectly clean. Water thing is empty. The dryer hasn’t had much use, it’s in a holiday let. I took off one or two panels and couldn’t see anything untoward.
Any ideas please?
Mike.
PS, PNC 91601409802 S/N 04412176Auto-dry is an AUTOMATIC programme (requires laundry to work) timed runs for set time irrespective of load or no load in drum.
Re: Miele G638I plus dishwasher
I must have good puff, then us Irish are made differently 😀 !
You could leave pressure sw’ in situ, take off cable connection & meter it when motor starts 💡
Re: Miele G638I plus dishwasher
You can put a meter on the terminals, switches should change over when you blow in to it
