Forum Replies Created
-
Posts
-
Re: Hpt WMA 10
control Board will have blown – sometimes you can repair them others you cant!
Hope this helps,
Brian.Re: CDA CW494/1 tripping fuse
It will have one of those askell wash pumps fitted on this machine – so would be my guess too!
Re: indesit wia121uk
Had a couple of these m/c in the past – both pcb! Sent the modules away to EMW to repair. Probably the same here Iam thinking!
Wouldn’t put much store by the fault codes on this machine.
Hope this helps,
Brian.Re: Bosch d/w SGS5318GB/12 module (part no 264877)
QER 👿
Not much luck with them ~ Very hit & miss ❗Re: Bosch d/w SGS5318GB/12 module (part no 264877)
Circulating motor running all the time, even when programme cancelled.
Checked motor for earthing fault no fault found – what else could it be other than pcb?
Brian.Re: Bad news day.
Doctors all now agree – living is bad for your health & will almost certainly end in death – there are exceptions of course i.e. jimmy saville & rupert murdoch and a few others…. 😆
Re: Qualtex Ordering Software ???
When the rep calls round he installs the programme on your computer, with pass words etc, then your up & running.
Re: INDESIT IDL530
Always a good idea just to check for a dry joint at heater connection first, before ordering new one.
Common fault these days!
Brian.Re: cda dish washer cw447
Suspect this is a whirlpool machine, if so continous beeping could indicate ntc failure.
Hope this helps.
Brian.Re: Diplomat ADP 8242
Checkout smeg dishwasher known error codes above you should find the reset procedure in there.
BrianRe: Bosch d/w SGS5318GB/12
Thanks for your prompt reply Redflame. I tested both the heater element & the motor for earthing faults both ok.
I suspect that it’s the control module, but always reassuring when others point the finger in the same direction.
Does anyone know differently though?
Brian.Re: White Knight cond’ dryer 797SVNC
Thanks Chris for the quick response – will let you know Monday.
Brian.
