Forum Replies Created
-
Posts
-
Re: Beko WMA10 – Am I missing something???
Any splits in the drum at the back or front where the circunferance meets them,usually only found by pushing hard at seam to see if it will part.
Re: w’pool top loader (3rlsq8000)
Is pressure switch chamber blocked causing too high water level?
just a thoughtRe: Candy F/F thermostat
Is stuff freezing in the fridge?is there ice building up on the back of the fridge,is the frost reaching where the thermostat phial fits,is the phial held tightly by the screw,one of these may
be the answer.
Was the old thermostat open circuit?Re: Whirlpool 3LEC8646KQ4
I have the diagram and parts list for that number but with a different variant on the end.They are all very similar it probably refers to the facis.
The relay is encompassed in the motor,much like the old servis washers years ago.
Motor could be fluffed up causing problem also.
If you want some info pm me with your email.
BGRe: Whirlpool 3LEC8646KQ4
Should be an R in the model no I think.3RLEC8646.
Door switch is worth a good look first !
I have parts and diagrams if they are of any help.Re: refrigeration repairs.
Macmillan do a good basic one written by N Cook called Refrigeration and Air Conditioning Technology.There are many others available if youy visit a decent library.
Good place to start and then you can take it further if you wish.Re: HENEKEN HALF HEIGHT BENCH TOP FRIDGE PROBLEM
Worth fitting s condenser fan try here but make sure you get the right voltage what ever it says on the fan you have.
Re: Tips, Tricks & Shortcuts
Magnets off old microwave magnetrons are ideal for slipping over solenoid valves (refrigeration) to check their mechanical operation.Stick them on the inside of the van roof and keep giving your screwdrivers a recharge.
Re: apm6816 f /freezer
adv wrote:took wires off this state goin back monday but didnt take note. its a whirlpool type state, do they wire up same as the dan foss an vts.? ie live 3 brown. compreeser black 4. light 6 help lads? 😆 if a mind hink ther dif 😆
Yep same as no 3’s
Re: Fixing somebody else’s mess
They somewhat lump us all together,followed one who had alledgedly fitted a wash pump for £100 ish on a indesit/hotpoint she didn’t say until I got there.
Tipped it over and she said he only took the side off,fitted wash pump from the side 😯 don’t think so.Not only that the leads were off the drain pump.Ex manufacture’s engineer too .
She gave up trying to get him back and was moaning and going on about poor service and calls me to pick up the bits so to speak.
If they tell me over the phone that I’m following someone I always say no thanks.Re: LEC F/F
loopey wrote:Done a few of these latley its a rebadged beko , a pound to a penny it has
a TEE , or turk electic comp on it.. probly week comp , and the watery sound you can here
is oil in the evap , you will have to flush it through ..hth phil
Thanks,it’s not worth doing,fitting a new comp and flushing out.
have LEC bit the dust then ?Re: Hotpoint Future RF187B – compressor runs continually
Sounds like you may have a refrigerant loss or slightly under performing compressor.
Would neeed an engineer for either fault.
BG
