Forum Replies Created
-
Posts
-
Re: Hotpoint WMA62s
Phidom wrote:Yes, I had one where the whole alloy bearing housing broke off the back of the tub. They do rust in well. 🙁
😯 athletics could do with a decent hammer thrower,how you fixed?
Re: Baumatic bdw13 e3
Whilst you have the door off to check wiring remove control PCB and check printed circuit for a blackened solder area which could be the heater relay,it can be re soldered if that is the problem.
BGRe: Hotpoint WMA62s
Almost lump hammer size 😯 ,sometimes the bearing comes out with the shaft,a brass or copper drift will also help.
Worst scenario is a new drum shaft which will make a better alround repair anyway,shaft and bearings together are cheap enough,I’d be tempted to consider changing both.Re: Water removal…….. hand pump……….!!
My batteredlooking rowenta is the dogs wotsits,pulls water out through drain hose along with a any carp in there.
Was second hand in 85,couldn’t manage without it.Re: Bosch WAE24162UK/01
Of course we have psychic powers,how many times have you heard “well,it won’t do it now you here”.
I did have a bit of strange feeling but put it down to the vindaloo Sunday pm 🙂Re: WHIRLPOOL ADP2440WH
Probably the capacitor on the side of the motor,which gives it a kick to start if it fails the motor hums and gets very hot,hopefully no damage to motor windings.
Probably £15ish so worth a try part no 481212118132.
BGRe: Free Estimate.
Had a pub landlord ring from 20 miles away saying “can you give me a free estimate?” I said no problem “if you give me a meal for two and a decent bottle of red it’s a deal” he said he’ll speak with his wife and ring back 🙂
Re: Hotpoint wma32
Have you had a look ? sounds a strange one.
Is the valve opening and closing quickly for some electrical reason causing water hammer in the pipes,megger all round!
Domestic pipes should be secured enough to prevent water hammer.Re: Ignis ADL348 dishwasher not starting, gives 7 flashes???
7 flashes,represents flow meter fault(measures water going into machine),worth checking water is switched on,filter in inlet pipe fitting to machine is clear.
UNPlUG before handling machine.
Whirlpool agents etc should be able to supply spares for this one if they are required
BGRe: Ignis ADL348 dishwasher not starting, gives 7 flashes???
Would be helpful if you can supply the 12 digit service no beginning with 8.
Possibly fault on water flow meter but would need to check on the servis no first.
BGRe: Bosch WAE24162UK/01
Ran it through a 60c,checked the element and motor but no earth fault at all.
The machine is now behaving normally,I did previously change the level tubing but it still played up afterwards so that wasn’t the solution,looks like a pcb fault of sorts,I’ll have to wait and see what happens.Re: Bosch SGS56E02GB/47 not completing cycle
All in one tablets are a recipe for disaster in a hard water area,check the hardness of the water and set your machine accordingly,then use salt,rinse aid etc.
Your machine will wash better and last longer.
Do your glasses gleam or do they have a cloudy effect on them,the latter I suspect.
