[Tubs]

Re: Zan ZSF6120

Hi Paul

Check PCB for dry joints on heater supply may look o.k but worth running your iron over just to be sure

Steve

[Tubs]

Re: Indesit Dv61/1 door handle

Hi Tony

Door handle number is C00053772, its says this is black? is that correct?

Steve

[Tubs]

Re: hotpoint mistral

Hi,

Baffle is controlled by the module, which in turn receives info from thermistors.
This keeps the baffle open all the time the fridge temp is above the set temp. If the baffle is open and the fridge is still warm check that the vents/ducting to the fridge compartment are not ice up, hence reducing/blocking airflow. did you change the evaporator thermistor?.

On early models this was green in colour and gave lots of problems even though no error code was shown when you switched the appliance on and it did a self check routine. evap fan should kick in when evapoator temp reaches -15.

Hope this helps
Steve

[Tubs]

Re: Hotpoint BS63Eb built in oven

Thanks Johnnyj

Will check out door lock and possibly module

Cheers
Steve

[Tubs]

Re: service wmwd m6012w

Hi allan
Would check to see if thermostat has welded itself together. if its mechanical of course. if thermistor check resistance readings

Steve

[Tubs]

Re: Testing or Bypassing Door Interlock

Got to be a wind up surely. I can safely say I sleep at night.

Steve

[Tubs]

Re: Wiring Diagram for Stoves 059056600 Range

Hi Walnut,

I may be a bit late, dont get time to log as much as I would like these days.
There are two wiring diagrams for this cooker. Have both if still required. Will have to fax them though as they are paper copies.

Must be quite common as have come across this before.

Steve

[Tubs]

Re: Hotpoint WMA40

Thanks Martin, Just what I was after, machine sorted now. :tup: Usual motor loom chafing and taken board with it, once again thanks

Steve

[Tubs]

Re: AEG SANTO1688

Hi

P.C.B for sure, Had this twice and also confirmed by my good old friend Mr AEG service engineer.

Steve

[Tubs]

Re: Miele novatronic W149 washing machine

Thanks Seamy,

Yes its a top loader, not come across this one before.

Machine just sits there doing bugger all, is in a confined space so wanted some direction before I just start pulling bits off it.

Thanks

Steve

[Tubs]

Re: Bosch SPS6462GB/06 pulsing?

Had similar fault on servis dishwasher last week. Although the dishwasher was filling the circ motor just pulsed on off, 😕 turned out to be pressure stat contacts welded together, strange because the unit washed ok for about half an hour, then decided to flood.

Not sure if your dishwasher has pressure stat though, its not a model number I recognise.

Steve

[Tubs]

Re: New world built under oven CK13548

Hi Dave,

Yer my thoughts exactly, all four diodes meter out o.k. 😮 Unless they are breaking down under load, usually though you can determine the duffens with your meter

Steve

[Tubs]

Re: Bosch Dishwasher SGS6302GB/13

Hi Alan

part nos. are (bosch)

lower door seal 298534

frame seal 263096

Steve

[Tubs]

Re: help with zanussi wahing machine problem

Timer,
:tup:

I’ve had a few of these.

Steve

[Tubs]

Re: Stoves tech info

Ordered DVD from stoves, part no. for your info is 082715900

Steve

[Author]

Posts