Forum Replies Created
-
Posts
-
Re: Servis M9310 missing cycle
Hi
Posibily a motor fault if machine fills then goes straight to pump and end .
Time for an engineer to check machine.
Unplug machine before removing any panels or looking at the motor
Re: NEFF Dishwasher programme ending too early
Hi
What type of detergent are you useing ie: powder / 3or4 in 1 tablets
Mike
Re: Hoover NW AC178 width – court case
Hi
from 1994 product data book Classica and New Wave range
height 85 cm 33.5ins
width 59 cm 23.2 ins
depth 58 cm 22.8 insMike
Re: beko wma 17151 error code
HI
Flashing PRE WASH LED is child lock on, you have to press both second and fourth auxiliary function buttons at the same time for 3 seconds to cancel child lock (see page 10 of user manual )
MIke
Re: HYGENA APP4210 COOKER HOOD
Hi
Thanks for that it was customer who gave me the number I have not looked at it yet
Mike
Re: 51-BS-08 Bosch Pump
Hi
Do they look like ASKOL made pump motors , Samsung have had lots fail with impellors falling off or noisy, and asking for all failed pumps to be returned for checking. They are made by ASKOL in Brazil , ASKOL made in Italy seem to OK
Mike
Re: SAMSUNG Q1636SGS MOTOR ACTION
Hi
New PCB will fix problem. Motor should be OK
normally only PCB requiredMike
Re: Creda 49715J cooker
Hi
In the user instruction manual it says “The control panel and hob are illuminated when the push switch is operated”
Mike
Re: SAMSUNG Q1636SGS MOTOR ACTION
Hi
Main PCB fault have changed a few , Motor judder is main symptom.
There are no visable signs of a fault when you look at PCB.
Change PCB and machine should work OKMike
Re: Hotpoint WD420 – Long wash time?
Hi all
The drain pump runs at start of some programs on some machines so if drain hose pushed too far into drain down pipe it will syphon water . Went to a new Servis machine last week , customer had put machine on for first ever wash and went out shopping came back 4hours later clothes still dry but water going into machine but never filled to correct level because drain hose was pushed into down pipe to far and syphoning out . repositioned drain hose and machine works fine,good job she was’nt on a water meter.
Mike
Re: Servis Quartz Washing Machine
Hi
At the end of a wash the clothes should be cold as all the rinses should be in cold water. If clothes are coming out hot, the fill hoses are fitted the wrong way round.
Mike
Re: hotpoint bwm12 smell
Hi
Have you done a maintenance wash at 90deg with a decent soap powder this needs to be done regular if usually you only do low temp washes.
Mike
Re: problem with proline pdw080
Hi
Posibily the flood protection has brought the drain pump on.
Pull machine out tilt backwards at 45deg to see if water runs out of base, if it runs out then you have a leak on the system somewhere.SWITCH OFF AND PULL PLUG OUT FIRST
