[Washman]

Re: Blomberg 1501AAA rinse

Hi

The pressure switch is factory set ,so do not attempt to play around with it, you will most likely end up with a flood . water level should be OK for rinsing. Unless pressure chamber is partialy blocked stopping machine from taking correct level of water.

Mike

[Washman]

Re: Smart Vac Z1490 or Electrolux Airstream Z1490

Hi

Have been looking around and from what I can see they are the same cleaner . and use the same bags.

Mike

[Washman]

Re: Ultima WD865 creasing clothes badly

Hi

All the older washer dryers instructions always said to dry only half load because a washing machine drum is to small to dry correctly, and they always creased things if you put too much into the drum to dry. If they say it will dry a full load then it should. but just try it with half a load to see if this makes a difference . If it then only works correctly with half a load complain to Hotpiont .
If you look into the drum of a full size dryer the drum fills the whole cabinet .

Mike

[Washman]

Re: Ultima WD865 creasing clothes badly

Hi

When using the dryer are you following the instructions to only dry half a load . If you try to dry the full load that you have washed it will crease . Split the load in two.
Please read your instruction book about drying cycle.

Mike

[Washman]

Re: Servis identification problem

Hi

Model number is M3120W . Module should be 546060200 which is lattest part no on the disk

Mike

[Washman]

Re: Hotpoint 7810

Hi

Try this from Connect 5031689609029 £27.73 trade

Mike

[Washman]

Re: Bosch WFF 2000 GB Temperature problems

Hi

Did you disconnect the inlet hoses at he back of machine , you may have reconnected them back the wrong way round if machine is finishing with everything hot . Becuase the rinces should be with cold water so should be cold when you take things out.

Mike

[Washman]

Re: Servis appliance in warranty?

Hi
One year

You will need proof of purchase to start with.

The first 4 digits of the serial number are year of manufacture

Mike

[Washman]

Re: Advice/help required

HI

Looking at the picture of the pulley it looks as if the rear bearing is coming out of the housing, could posibly be a case of a new tub.

Mike

[Washman]

Re: Bosch WFX2868GB Water Ingress

Hi

The warranty only covers manufacturing faults and break downs , water coming from an external source and getting into the workings of the machine is not a manufacturing fault .

Mike

[Washman]

Re: Fridge/Freezer required.

Hi

Insulation on modern refrigeration is thicker than on the older type so internal space will be smaller for the same external dimentions.

Mike

[Washman]

Re: salt left on crockery

Hi

i have a slight salt bloom otherwise it works fine

Do you mean a white residue on glasses etc, this can be caused by several things . are you using 2in1/3in1/4in1 tablets or individual powder/salt/rinse aid are spray arms rotating freely are you using the correct dose of detergent for your machine

Mike

[Washman]

Re: white westinghouse cooker

Hi

If the clock has stopped working then this is most likely the problem , new clock required .

Mike

[Washman]

Re: HELP BUILT IN DISHWASHER PARTS

Hi

Servis model no 02-800270 uk

Mike

[Washman]

Re: looking for the ceramic glass that goes on my cooker its

Hi

The ceramic glass is going to be very expensive . Probably about £150.00 to £200.00

Mike

[Author]

Posts