Forum Replies Created
-
Posts
-
Re: Indesit gas cooker burning bottom of food.
there is not a fsd on these gas cookers, they have thermocouples
Re: Miele Dishwasher inlet fill fault – HELP!
may be overfilling, check the fill system, they can get blocked and cause overfill and then register it still has water inside even though it has drained
Re: Indesit D41 stuck at start of cycle
there is water leaked into the base tray caused by overfilling or oversudding. Tilt dishwasher back 45 degrees, the water will come out onto the floor so get a towel ready, if it happens again check components for leaks
Re: Good
more or less same in london area, still light at 3.30pm pitch black at 4.15pm-roll on spring!
Re: Oven Table
got mine from merloni. it is adjustable and folds flat, dont know the part number though
Re: electric oven no back plate??
philips EKC006 branded ECKO had a similar design-removed from the back, havnt seen any of these for years, they used to make a double oven -2 single oven size, not the usual 1 and 1/2 size, they weighed a ton!
Re: How do you take the tops and sides off a Rangemaster?
i repaired a rangemaster today. Just before the join where the 2 hobs meet, there are 2 black screws about 25cm apart on the right hand hob
Re: electric oven no back plate??
some candy ovens have no backplate and the fan and element are accessed by removing the rear casing and then removing the sub assembly with fan motor and element
Re: How do you take the tops and sides off a Rangemaster?
take out 2 screws on left of hob top, remove screws behind the grill at back and the right hand hob will slide off, done loads-easy
Re: Hotpoint Washing Machine Bearings
the 0035 should state that the bearings are the 35mm type and not the 30mm type
Re: Is it a fault? BSH WAE24364gb/11
i have had this on a bosch washer drier and it was something the customers child done by pushing buttons in a certain sequence caused the child lock, i couldnt clear it but a bsh friend sorted it, you just have to know the sequence of button pushing needed.
Re: gas training
there are no adjustments for gas rate or gas pressure so with cookers it is straighforward. As long as you are getting around 21mbar to the appliance there is not much else you can do
