Forum Replies Created
-
Posts
-
Re: Hoover TC50 Dryer / Ignis cooker
Sure? Yep.
It’s definitely a Whirlpool, the 12nc tells you that. The 5th, 6th and 7th numbers of the 12nc are the model.
The part number for the element may well be superceded by now but looking for that number on Sios should bring up the new number.Brian
Re: Hoover TC50 Dryer / Ignis cooker
Model is AKL827/WH, is indeed a Whirlpool.
Part number I have for the element is 481925928847.
Hope this helps.Brian
Re: Diplomat ADP8322 trips main switch!
Not draining, blockage or pump fault.
Tripping sounds like the base may be flooded.DP
Re: damaged fridge/freezer worth getting repaired ?
Time for a claim on the house contents insurance……… accidental damage?
Re: American Fridge Freezer Whirlpool S20BRSS31-A-G
I suspect that this machine is 2003 or older and has the older type boards hence the “cf” when you fitted the new front board.
As to the fault you’ve got, how long did you wait after fitting the new rear board? When you first switch on it should go into defrost mode. Takes about 20 mins before it actually starts up.
Brian
Re: American Fridge Freezer Whirlpool S20BRSS31-A-G
Most common is the front pcb. You’ll have to check the serial number to see whether you need both boards changing.
Brian
Re: Whirlpool d/w DWF415S (854541515760)
simtoms wrote: Now the machine drains, fills and circulates but only in irratic pulses, simultaneous with green LED as it flashes on,off,on,off etc..
Does this pulsing only occur when it’s trying to circulate the water?
If it’s an askoll pump then this is likely to be the problem. You get similar symptoms when the base is flooded and water gets onto the askoll motor connectors.Brian
Re: Diplomat ADP8322 – two flashes error
And the water that was in the base, probably shorting the askol wash motor, has leaked out or evaporated.
As it’s now running OK I’d guess that the original problem was overfoaming leading to a spillage into the base.DP
Re: Whirlpool AWG320 Spin Problems
Is this the model with two switches on the door interlock?
If it is, new interlock has one switch and cures this problem.
BrianRe: white knight t/d cl767sv
williemac wrote:reset stat and it will go again no blockages
Just to make sure I’m reading this right. Do you mean it runs and trips the stat after 20 mins?
If so and assuming air flow across the heater is ok I can only think it may be a faulty stat?
Brian
machineman wrote:still icing up and not defrosting
Emmm, this is the first mention of icing up and not defrosting.
I’ll bring the manual home again tomorrow, if no ones answered I’ll see whats in there.
Brian
Re: Whirlpool ADP6946 F5 error
Unless they’ve changed their fault codes it’s reporting a blocked spray arm.
As it’s a new machine I can only suggest calling and getting an engineer out to it.DP
Re: comet
Spoke to a Comet engineer today. Apparently there are redundancies pending in South Wales. Don’t know why or if it affects anywhere else.
Brian
