[electrofix]

Re: running modern L.G. washer on generator.

used to do a few disco’s in my youth did a few on the beach had to have a different generator on the turntables otherwise rercords would change speed when generator did
i found the best way to sort the problem was to run a 500w flood lamp to stabilise genny
using a washing machine is similar as loads are placed and removed the motor needs time to react hence voltage and frequency variations

Dave

[electrofix]

Re: electrolux ESL63010 (D/W)

sound like

but if you want the service info let me have PNC number

and an email address

Dave

[electrofix]

Re: running modern L.G. washer on generator.

before you do i would ask LG they may not guarentee machine unless on mains supply

Dave

[electrofix]

Re: electrolux ESL63010 (D/W)

at 150v to valve although this seems low i would still expect valve to open but as you say if this is the case then the pcb should be giving 240

sound like the triac that feeds the valve is faulty and only giving half wave supply

are you getting any fault codes ?

Dave

[electrofix]

Re: Whirlpool semi integrated dishwasher

open trade tech forum at the top is a load of sticky posts that always stay at top for common information

on is called known error codes

http://www.ukwhitegoods.co.uk/modules.p … topic&t=40

all this type of info is in there
on these types of forums you have to learn to dig about most questions have been asked before so if you can find it than the job gets sorted quicker

Dave

[electrofix]

Re: Whirlpool awz 410 Help

hi Sean Og welcome to the madhouse lol

check brushes

check heater some whirlpools wont start if heater open circuit

Dave

[electrofix]

Re: Whirlpool semi integrated dishwasher

look in known error codes its there

Dave

[electrofix]

Re: 25 yr old Tricity Ckr integr. 4175 needs hinge repairs.

god i am having to think back now

you say door opens and closes but does not lock so cant be hinges

on some old tricity’s you turn the knob on the outside of the door to open and close them part inside door snaps can go with a bang as it has a small spring attached

part still avail in stock at qualtex

part number CS27

hope this helps

Dave

[electrofix]

Re: Electrolux EOC6630X oven error codes

manual does not mention 3 flashes

yellow light is flashing
1X cannot lock
2X cannot unlock
4X temperature sensor defective
5X basic temperature too high
6X electronic too hot
7X wrong connection
the red light is only flashing as a counter, interval 10 sec

if you want manual let me have your email

Dave

[electrofix]

Re: CAPLE WDI 2201

sound a bit like the button to select the spin speed is stuck

Dave

[electrofix]

Re: CAPLE WDI 2201

what do you mean by display cycling ?

Dave

[electrofix]

Re: aeg lavamat W1059

fault 5 is motor based

motor traic short
no signal from triac
motor traic sensing circuit faulty
motor relay contact sticking

to find which one you have to go into diagnostic mode

check motor for earth faults had this fault once and motor was wet

Dave

[electrofix]

Re: creda simplicity w100fw drum bearings

if bearings gone badly can rub on heater and destroy it

Dave

[electrofix]

Re: creda simplicity w1000fw drum bearings

this is the standard old hotpoint design great machine to work on

front comes off machine
remove font of drum leave outer drum in situe

pulley threaded onto spider and locked with 30mm nut

spider and bearing available very cheaply

can do repair after experience in about 75 minutes

Dave

[electrofix]

Re: Hotpoint WF340PB lights flashing

panel looked perfect

Dave

[Author]

Posts