Forum Replies Created
-
Posts
-
I would get a multi meter and measure the valve coils. if one has failed the machine would fail to fill and that would give you a tap icon
coils should be 3000 to 5000 ohms approx
Dave
if you want Better bearing you could always find a local bearing supplier and get 6206 and 6207 bearing but you still need the seal which is special to this range of washing machines . if it is a 30mm shaft it uses smaller bearing and another seal
the gen kit does use a rubber shrouded bearing but i dint think there is a weep hole in the rear drum half so it makes no rael difference
as said before check your spider first and if you go ahead pay careful attention to the wiring harness as they rub on the concrete weights if badly routedDave
you could fit the gen set which might be
https://shop.ukwhitegoods.co.uk/c00202418-washing-machine-bearing-kit
if the shaft is 35mm
some units used a 30mm shaft and there is no easy way to tell although the 30mm often had plastic pulleys
also due to spider corrosion its advisable to strip the unit and check the spider first
Dave
if the screw comes loose after you tighten it there must be a problem there. if it was tight it would not loosen which leads me to think corrosion may be a problem due to age
Dave
you dont give any details about the part you are looking at but
https://shop.ukwhitegoods.co.uk/w0000057-hygena-cooker-hood-switch-pcb-assembly
this is in the site shop
Dave
matrixresonator wrote:I’d recommend getting the gas pipe moved if thats possible, otherwise you’ll be revistiting this issue again.
Agreed
safer and more practical
Dave
well dont know how any site can list a bearing kit for them when its a sealed tub
looked up 2 units as there are 8 varients all have cluster welded drums
thid is one of them but may not be yours
Dave
https://shop.ukwhitegoods.co.uk/3484160316-washing-machine-tank-assembly
not sure with panasonic
get a torch inside the drum and look through the holes and around the door aperture to see if you can see it
after that the 2 ways on are
1 the sump hose
2 the heater (can be a pig to out and back in)Dave
most likely correct but this post is now 10 years old so i think they may have a new machine now
Dave
steveb21 wrote:
Is it a simple case of replacing the board with a like for like?
.wish it was that simple
boards dont blow for no reason, another component in the machine has popped it. the chances are if you replace the board it will destroy that tooto post pics , host pics on another site like google pics and post a public link
Dave
