Forum Replies Created
-
Posts
-
no but the heater get hot in dry mode and could lower its insulation resistance
we need to hook up something with no earth which is why a lamp is good
then try dry mode and see what happens
if it gives F08 then it cant be a heater fault to earth
Dave
ok small leakages to earth can upset electronics even though they cant trip the rcd
you could try connecting a lamp across the wires ( not an led one) to simulate the element without chances of earth leakage
was wondering if as the heater got hot the leakage increased giving rise to your fault code
Dave
even if a switch operates does not mean its electrically ok
test the switch and check wiring to the board
Dave
yes have seen that
dont want lots of work at my age but a lot of these networks pay lower wages compared with your own sourced callsConnect has a similar scheme going
Dave
washingmachinewoman wrote:
With the phasing out of vented and condenser dryers, I can see this type of work fast becoming our bread and butter
Lucie
hopefully lol
Dave
dont know with this one but some manufacturers do all sorts of silly things. there is a beko where to change the oven door hinge recievers you have to remove the oven cavity
all you can do is look around. from the top maybe an option
you can use string to get it into place and then juggle it to get the screws in
Dave
if you let me have the complete serial no will see if i can find a part no for the door harness
you could go back and look at the harness at the bottom of the door first if you want to make sure
Dave
cant see any display card listed but that could because have not got serial no
had one the other week where display went on and off, replaced wiring harness and all ok
harness was very cheap and Aswo had stock
Dave
if the latch is in the closed position you can flip it forward using a length of wire coat hanger with a 5mm right angled hook on the end
insert it into the lactch hole and hook it behind the latch mech and pull
put a safety loop on the other end and watch your eyes if it slips. best to hold it with pliers
Dave
not sure why smag use a different motor but I would check the specs of both the smag unit and the replacement
was wondering why the smag motor was so expensive and it may be either quality ot it could be increased air flow
look at specs on motor wattage or air flow
if the unit is being vented outside be aware of the outlet hose sizes. did some guarentee work for one manufacturer and we were instructed to check the hose size and if to small to walk away and void the warranty
did not want you to replace it and find the new one is not as good
Dave
