Forum Replies Created
-
Posts
-
put the correct breather hose in it and bung the other hole up? the only problem you will have is the fact that it needs to breathe somewhere so the water level will be correct
1 – prewash
2 – wash/rinse
1+2 – conditioner – compartment
3 – dryer condenser flushyep, u got a faulty valve – its been sat waiting for water after its initial test fill
thats an early version, and should have a relay pcb, near the timer, attatched to the bezel, the door switch on that is just a switch
part number C00207999 should cure it
this has been discussed previously
http://www.ukwhitegoods.co.uk/modules.p … lt&popup=1
hope this helps
again, theres two versions, if thers no relay pcb near the timer, otll need a nitron lock.. serial number needed to confirm
no its ok, its a thermistor
the resistance changes according to water temperature, so thats fine
just check the valves next, just to be sure
you probably just had a dicky pump tbh.,,,, f11 is failing to activate pump…. but the f8 is a whloe new ball game
right ill do this
why would it have a relay pcb?
explain that to me?
the customer is wrong
they probably didnt notice the switch didnt stay in, because it used to start when they pressed it
if the switched stayed in, the machine would RESTART when the door is shut and that doesnt conform to current safety standards
i wont repeat myself… you keep ordering the SAME part and come back when uve fixed it with a RELAY PCB
