Forum Replies Created
-
Posts
-
yer, in fact, the customers so good, he doesnt know whats wrong with it
u should bare in mind he could have done ANYTHING to that machine, ie. took wires of and put em back on wrong, etc
and just remind him that live testing is dangerous, and could introduce further problems
he must have, or he wouldnt know there was no supply
customers… their own worst enemy, and self fixers who cant fix are worse
typical customer
it takes up to 5 minutes before the fan has any kind of supply
check condenser valve, clean out condenser
if hes had no fault codes, condensers likely to be blocked
yes there are front pads, but they rarely go, to be fair
the rear bearing can be changed by taking of the small panel at the rear, remove the pin and it will come out
the front ones, yes the drum has to come out
a pcb (and an eprom, no doubt ) would cost you as much if not more than the £90 hotpoint charge
chuck it in the bin and buy a miele
u need to get in the diagnostics m8
not sure how to do it on one of them, im sure theres a serviceforce guy around who might be able to advise
or, ideally, buy a samsung and get in the back and chip that iceberg off, and use that
if the titanic would have hit one of them, it would have sank in less than 3 minutes
and if the thermal fuse has gone, find out why!! fan not working, condenser blocked etc, they dont blow for no reason generally
could be pressure switch.. when u cleaned the sump, did u stick your fingers up the hole to make sure theres nothing there?
does it drain ok?, how does it look when u watch it empty?
