Forum Replies Created
-
AuthorPosts
-
helo_75
ParticipantRe: SAMSUNG RS21DCSV – Fridge not working
grrr hes at it again
lol
thermal fuse… inexpensive part
cures problem
yes they go faulty… id love to know how old your car is.. do u have repairs done to that ? or do you just take it back everytime something goes wrong? im sure ford would change a car everytime summink went wrong? surely? hmmm 😯
helo_75
ParticipantRe: New American F/F advice please
lol, this is gettng funnier
someone doesnt like samsung, do they?
helo_75
ParticipantRe: Hoover Fridge Freezer
quite possibly the door switch is faulty
what that does do, is leave the light on permanantly.. that then leaves a bulb that has become warm inside the fridge , and its impossible to cool
take the bulb out and run it without it in, see if it works
that’ll answer the quaestion
helo_75
ParticipantRe: samsung rs20 f/f
hi beetlebug
yes defrosting it cures this fridge freezer problem quite often
if the problem re-occurs frequently, there is a modified evaporator cover available or the thermal fuse is faulty
unfortunately there are people around who, because they bought a fridge freezer that went faulty,think someone else should burden the cost
things break down, its fact, if u read up on fride freezers in general, the amount of times the compressor switches on/off.. how often fans run, its amazing they last as long as they do at times
things change, times change, designs change
see how you gon on.. its not a hard fault to cure if it re-occurs
hope this helps
helo
helo_75
ParticipantRe: Samsung RS21JCSV
u ever seen a samsung with a 6 yr warranty?
name suggests all
😉helo_75
ParticipantRe: Hpt WD420 heater box modification 39 date code
lol, ud make no money….
yup, on later models, the eproms diff, so thats gonna be a prob.. however, its down to the termistor i believe, and that can be swapped over
mybe, just maybe, if they designed summink that actually worked, it would be better
when was the last time ne 1 changed a bosch washer dryer fan motor?
all the need do is make a fan motor with a split pin and a proper nut on it instead of that stupid collet idea and itll be fine, but oh no
i wish i got paid the money the ppl who think these things up
helo
helo_75
ParticipantRe: Hotpoint FFS70S – Blocked fridge drain hole
ggrr.. how old is it?
some of them had the drain pipe foamed in too close to the evaporator, and water froze in the pipe
does it feel hard?
i normally take the pipe off the rear of the machine and blow up it
only way if it aint iced up
helo_75
ParticipantRe: Zan ZSF6120
ah well, soldered joints can be better than them edge connectors.. for sure i seen a zanussi dw set on fire cos of dodgy edge connectors…
manufacturers would tell u to change the loom wouldnt they
and .. can i ask are u actully nl servces, or just using their name?
helo_75
ParticipantRe: Rangemaster 110 thermostat
is this a dual fuel cooker? i.e does it have a gs hob and electric ovens?
helo_75
ParticipantRe: Hpt WD420 heater box modification 39 date code
and the part number is 1605710
it comes complete with the new coiled element and sheathed thermal fuse
helo_75
ParticipantRe: hoover hcs 1400
pcb and selector not communicating normally
its normally the selector to be honest
helo_75
ParticipantRe: Before It’s Removed…
i agree, but that was funny, dont suppose it would have been if the cat had died
strange, cos some woman got 4 months today for putting her bf’s cat in the washer at 60degrees
the cat died of heart failure ad severe burns
helo_75
ParticipantRe: Hotpoint CTD 80 condenser dryer f10
yup
if its a pcb controlled machine, yes it should have 3
would probably be best to change the whole heater assyhelo_75
ParticipantRe: indesit widl 126 dryer fault
theyre all common
its an indesit after all
just generally check for fluff blockages and/or things not functioning
condenser blocked is probably on the money.. but id get someone in, i once cut myself real bad getting one of those out, theres a LOT of sharp edges in there, and takes some experience getting it out
and i wouldnt be surprised if you fitted the fuse and it worked ok
keep us in a job, merloni!
hope this helpsUNPLUG if u want to investigate, and wear thick, protective gloves
February 5, 2007 at 9:11 pm in reply to: hotpoint aquarius ctd00 not rotating, making buzzing noise #203323helo_75
ParticipantRe: hotpoint aquarius ctd00 not rotating, making buzzing noi
how late is it?
on later models, theyve got the relay built into the door lock, and it would certainly do that if the lock activation pin was missing… im sure though that that particular variant is so new it should be under first year
next question?
is it the pump u can hear?
cos if theres nothing from the motor at all, as sure as eggs are eggs ittl be the timer if thats the case
omg they really are poor arent they?
-
AuthorPosts
