Forum Replies Created
-
Posts
-
youll see if the fan is out of shape
some people take it off and run it without to seeif its quieter
and if it is that.. an email to spares@ at the online shop will get you one
theyre not too bad
plug out,top off, side panel off (normally) the fan is on the end of the motor shaft
and of course, its f08
heater relay fault on pcb
if your competent enough, emw can supply you a programmed board
other than that your cheapest option is the ndesit fixed price repairs
bloody indes*it…. id bin it and buy a proper machine
haiers dont have welded tubs 😛
which is good, cos ll need to be putting bearings in them every month
top to bottom,top lightbeing one, what number light is flashing?
probably a pcb fault, but ts best to be sure
id first check the buttons on the front arent stuck ,thats the usual set up.. a good thing to check first, is unplug the machine, and after a couple of seconds, plug it back in , whilst watching the leds on the front.. they should light up momentariy
oh, and id check the plug to the front board whilst uve been working in that area
hth
rob
be aware, having a pipe to the hob does not mean theres adequate supply for both a hob and a double gas oven… you really need to consult a ‘gas safe register’engineer to work out pipe sizing and suitability
it would be foolish to buy one and not do the homework
oooohhhh noooooooooooooo
well
ull need a smart card, and a smart card reader
this has been discussed to death
might be worth giving tony a call at emw, he’ll supply it fully programmed, and fast delievery
the boards are fickle, just dont be shocked if theres something in the pump
quick mechanical check, and if everythings ok, itll bw the board
