[hotpnt]

Re: Hotpoint WD440G filter problems and general moan.

but that will not cure this persons machine, its his sump that is blocking up

[hotpnt]

Re: Hotpoint WD440G filter problems and general moan.

hi, the filter will only block, as helo says, if you are washing something that is causing it to block, bath mats, dog stuff, thats the usual cause, nothing to do with the machine, and no modifications available either,

[hotpnt]

Re: Hotpoint 30mm Seal (Again!)

Just a little tip, if the pulley is plastic it is likely to be a 30mm bearing, 35mm usually have metal pulleys, can save you time if you strip one down only to find you dont have the bearings to fit,

[hotpnt]

Re: Hotpoint FFA70 compressor

fixed? outcome?

[hotpnt]

Re: hotpoint aquarius vtd00

yep same kit, if you fit the seals kit you can get away with 2 washers at back, if the gap is still too big check the cabinet is all square

[hotpnt]

Re: Hotpoint TDC32

hi, when you say it cust out, is the whole machine stopping or just the heat? if its the whole machine it will be the relay up top

[hotpnt]

Re: WF860 30 mins to 37.

if it thinks the pump/sump is blocked it will add a rinse to try to clear, last one i had caught me out, i tried it empty & drained fine but still jumped the time up, changed pressure switch in end to cure it

[hotpnt]

Re: LEC T455CW

thank you,

[hotpnt]

Re: Hotpoint FFA70 compressor

was it the engineer who fitted the compressor that came back?, as it sounds odd, 30hrs should not have hurt the compressor, and the water noises you are getting are caused by low gas levels

[hotpnt]

Re: Hotpoint WD420 – T/Dry heat

hi, i would be checking the module plugs down the back, water can sometimes come out through the vent hole on top of dryer box, runs down side of drum & drips onto module plugs, often find the plugs burnt there, can cause intermittent tripping,

[hotpnt]

Re: creda c561e

the trigger board supplys the element when the stat tells it too, so if the element comes on without the stat needing it, it will be a faulty relay on the trigger board

[hotpnt]

Re: New Stickys?

Hi, can i request one please so i can take a peak, thanks

[hotpnt]

Re: Ariston AV1048C, drum not turning

ok when you say there is not much left of the brushes what does that mean?, they should spring out past the holders, if they are level then that may well be your only problem

[hotpnt]

Re: Budget ?

so you mean i can stop peddling my 12v generating excersize bike & plug my laptop back into the mains?? 😉

[hotpnt]

Re: Hotpoint FFA70 compressor

would agree with helo here, ‘water gurgling’ noises usually means low gas levels,

[Author]

Posts