[hotpnt]

Re: Hotpoint WF000 RCD tripping out

the molded plugs can also fail & cause tripping, have been to a live/neut short this week on one, mains suppressor had failed

[hotpnt]

Re: salt sensor

Glad it helped, remember though another 30 washes & it’ll be on again!

[hotpnt]

Re: Indesit WIA 101

yes, its a module failure

[hotpnt]

Re: salt sensor

why worry about it?, then again water here is so soft that you never need to top up salt, check the neon 1st

[hotpnt]

Re: Hotpoint WM55P Motor fixings?

1601888 is the slide bracket, dont think there is a number for the pin though

[hotpnt]

Re: salt sensor

there isnt one!, the module just counts the washes and after a set number (around 30 i think) the light flashes as a reminder to re-fill, to re-set pour 2L of water into the base, (this makes the p/sw contacts and makes the machine think salt has been added)

[hotpnt]

Re: Bosch WDF2000

loooking at connect & qualtex looks like a dial pushed straight onto timer shaft, anyone confirm please ❓

[hotpnt]

Re: creda w200fw

30mm bearing kit C00254590

[hotpnt]

Re: Bosch WVF2000

yep, just called customer again, its a WVF2000, thanks

[hotpnt]

Re: Hotpoint WF321 Panel Lights Constantly Flicker

hi, seen many of these with led problems, lights flickering or on permanently, would try the top board, usually about 80{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the times it will cure led problems,

[hotpnt]

Re: Hotpoint WD condensor NLA?

they are in very short supply. anyone with one on the van is being asked to return asap!

[hotpnt]

Re: indesit washing machine Wia111uk on off light flashing

stripey wrote:This is normal it is telling you that it has finished the prog and is ready to start a new one.

no, the light should go off,

as helo says it does need a new module, also beware if continuing to use it as it is a sign that the dial is no longer corresponding to the programme you have chosen, so you may well be selecting a cool wash but the board will run a hot wash, needs fixing really

[hotpnt]

Re: Hotpoint BFI62 Integ Dishwasher – Help! Dead Button.

have you tried pushing the button on the PCB directly?, with it removed from panel, there is very little room for error in the lining up of module button & actual P button, other thing to remember is that a lot of the new modules come without the buzzer fitted

[hotpnt]

Re: hotpoint aquarius washer dryer wd46

if it has 240v to the conditioner valve on the first fill it would be a wiring or timer problem, if there is not then it has to be a dispenser problem

[hotpnt]

Re: hotpoint wt761 wont turn off

that model does not use flashing lights to show erros, so sounds like the module must be at fault, are any of the buttons sticking?

[Author]

Posts